Suspension Enhancement for 2021 Chevy Silverado 3500 With Camper Shell

Question

Question:

My truck has the OEM Camper/Snow Plow Prep Package, and most of its usage is for carrying my 4300# Lance 995 truck camper. The rig sways and porpoises under windy and rough conditions and some suspension enhancement is needed but Im undecided amongst the potential add-ons available: Anti-sway bars, Stableloads, Timbrens and Sumo Springs. What would you recommend? The upper overload springs are in contact with the frame bump stops when the camper is on the truck, and the truck does appear level and not sagging. Thanks.

asked by: William C

0

Expert Reply:

The best modification to the rear suspension you can make to your 2021 Chevy Silverado 3500 is going to be the RoadActive Suspension System part # RAS3611-CHD. This gives you the support you are needing, the best stability, and unlike other options it actually gives you an improved ride quality.

expert reply by: Jameson C

0

Answer 1

I would not recommend the part #RAS3611-HD for your 2017 Nissan Titan XD. This kit is designed for heavier duty vehicles so it would make your suspension harsh. The part #RAS3611 is the correct kit you'd want. It will give you the suspension…

view full answer...

Answer 2

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 5

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 7

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 8

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 9

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 12

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Suspension Enhancement for 2021 Chevy Silverado 3500 With Camper Shell

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching