What are the Internal Dimensions of the Yakima CBX Rooftop Cargo Box - 16 Cubic Feet?

Question

Question:

What are the internal dimensions for this box? Particularly the height?

asked by: BenB

0

Expert Reply:

I confirmed with my contact at Yakima that the internal dimensions for the Yakima CBX Rooftop Cargo Box - 16 Cubic Ft - Black # Y66FR is 74 inches in length from the rear panel of the box to the front panel and 26 inches inches wide from side panel to side panel. The internal height is 12 inches tall.

expert reply by: Bob C

0

Answer 1

When determining which cargo box will fit the roof of your 2020 Honda CR-V, it really comes down to the hatch clearance. You will want to measure from the center of your front crossbar all the way to the line where the hatch and trunk meet. If your…

view full answer...

Answer 2

The Yakima CBX part #Y66FR is a totally new design from the older Skybox that you mentioned. This means that the lock assembly is new and updated as well.

view full answer...

Answer 3

I have attached a photo of the Swagman Tajo Wall Mounted Kayak Storage System, part #S65146. As you can see in the photo, the measurements may not work with your 18 inch deep Hobie kayak, but we do have a solution. I recommend the Rhino-Rack Storage…

view full answer...

Answer 4

The best setup here does depend a bit on what you're actually planning on hauling outside the vehicle. If the primary goal is simply to store excess cargo inside a box though, then the best option for your Venza is going to be with a roof rack…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 7

Yes, your kick sensor for your hands free liftgate will still work after installing a Class III receiver on your 2024 Toyota RAV4 XSE. I have linked an install video near the bottom of the page for our etrailer Trailer Hitch Receiver #e23ZR being…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

The Malone Universal Crossbar System #MPG201 is a more economical choice but it still does a good job. The design and quality of Thule's system is why they have such a large difference in price. Whether you go with the Thule Crossroads system…

view full answer...

Answer 10

The Rhino-Rack Roof Rack for Factory Tracks #Y02-490B-NT is going to be your best bet for the tracks on the ARE topper for your 2012 Toyota Tacoma. The weight capacity is 220 lbs like you mentioned, but that's going to be the highest you'll…

view full answer...

Answer 11

Hi Alec, The Inno Kayak Roof Rack w/ Tie-Downs #INA452 needs a 28" minimum spread so that the saddles sit at the right spot for the kayak and support the weight properly. This is probably just a general guide from Inno though because the length…

view full answer...

Answer 12

To add a hitch to your 2024 Toyota RAV4, I recommend the etrailer item #e23ZR. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a 4,000 lbs towing capacity, and a 600…

view full answer...

What are the Internal Dimensions of the Yakima CBX Rooftop Cargo Box - 16 Cubic Feet?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching