TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear

Question

Question:

We recently purchased a fifth wheel camper. I have mobility issues and need steps with a low rise. We have a keystone Avalanche

asked by: Rhonda

0

Expert Reply:

Most RV steps are going to have a drop/rise of about 8". The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear, # TLA8003, has a drop/rise of 7-1/2" when fully extended. For a four step, # TLA7834. Or a 5 step, # TLA8005. These come in a few different widths as well.

Please see the link attached.

expert reply by: Michael R

0

Answer 1

I checked with TorkLift and though there are not steps that are designed specifically as a custom fit for your 2017 Keystone Outback 210URS, but all you need to do is determine what your entry height is and go from there. For example, the TorkLift…

view full answer...

Answer 2

As you have identified, the entry height of the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear, #TLA8003 for three steps, and #TLA8004 for four steps, overlap in their application specs. The #TLA8003 is for entry height of 25-1/2" -…

view full answer...

Answer 3

I would be happy to help you figure out the correct TorkLift GlowStep Revolution Scissor Steps for your 2012 Rockwood 8312SS, but unfortunately I do not have a list that has the correct step for your trailer. To determine the correct steps you will…

view full answer...

Answer 4

With the measurements you provided me (Ground to top of threshold is 36 1/2, Width inside door frame 29 1/2, Width of stair bracket 27 1/2) I have two options for you. If you want to have an undermounted step I recommend the TorkLift GlowStep…

view full answer...

Answer 5

The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear #TLA8003 is designed for entry height between 25-1/2 and 36 inches. This is to the door threshold not the bottom of the compartment. If that is the case, then it will be a great option…

view full answer...

Answer 6

view full answer...

Answer 7

These are great steps, no negative concerns with the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear. However, #TLA8004 that you linked to is designed for an entry height of 32-1/2" - 44". If you have an entry height of 28",…

view full answer...

Answer 8

My TorkLift contact advised that on their GlowStep Revolution Scissor Step #TLA8003 the distance from the top of the frame bracket down to the top step is 7-inches. Unlike most others this step offers some adjustability. If you are at a campsite that…

view full answer...

Answer 9

The correct TorkLift GlowStep Revolution Scissor Steps for a 2017 Keystone Premier 30RIPR is part #TLA8003 according to TorkLift. That said, you could use the TorkLift GlowStep Revolution Scissor Steps part #TLA8004 so long as your entry height is…

view full answer...

Answer 10

Since you have the 27" wide entryway, the only additional thing we need to know is the "Entry Height." The attached photo will show you how to measure from the top mounting point to the ground. From there use the attached chart. For…

view full answer...

Answer 11

I confirmed with Gen-Y that the measurement from the center of the kingpin to the rear bolt-hole setup is 24 inches on the Gen-Y Shock Absorbing 5th-Wheel Pin Box #GY46FR. I went ahead and attached a diagram that shows this measurement.

view full answer...

Answer 12

The Lippert 4,400 lb axles use the same bearings and seals as a Lippert 3,500 lb axle so you can use the Bearing Kit for #84 Spindle part #BK2-100 or just the Grease Seal part #RG06-050.

view full answer...

TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching