Viking Solutions Rack Jack 2 Hoist Reach Dimension

Question

Question:

I need to know the the horizontal hoist arm dimension, specifically the horizontal distance from the vertical post to the hoist point. Thank you.

asked by: Karl

1

Helpful Expert Reply:

The reach of the hoist, as measured from the inside edge of the verticle post, to the outside edge of the hoist pulley guide is 17-3/4". See the attached dimensioned photo.

expert reply by: Les D

1

Viking Solutions 310-VRJ001 Rack Jack 2 Hoist Reach
(click to enlarge)

Answer 1

No, the Viking Solutions Kwik Hoist - Tree Mount - 400lbs Item #310-VKH001 does not rotate side to side. If you're need one that will we offer the Viking Solutions Rack Jack II Hoist with Winch for 2" Hitches - 300lbs #310-VRJ001 and…

view full answer...

Answer 2

The Viking Solutions L-E-Vator Portable Loading System #310-VLV001 platform is 16-1/4" long x 15" wide and can raise up to 40" so you could lean the Kayak against the vertical poles and the platform and raise it to help get…

view full answer...

Answer 3

The Viking Solutions L-E-Vator Portable Lifting Tool #310-VLV001 that you referenced has a 300 lb weight capacity so it would easily handle a 140 lb generator like what you have.

view full answer...

Answer 4

The Viair Portable RV Air Compressor Kit #VA39WR does not give you the ability to set the compressor to a specific PSI. The compressor features an on/off switch on the compressor to shut it on and off otherwise it will continue to run unless the…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 6

Hey Robert, for a 5,200 lb Dexter Torflex axle like what you have we have the Dexter lift kit part #K71-724-02 which will give you a lift of 2-7/8 inches.

view full answer...

Answer 7

Thank you for the pictures! I reached out to my contact at Dexter Axle who was able to confirm that you have #11 Torflex axles so the correct lift kit is part #K71-724-02. Since yours has top mounting holes you also need the bracket kit #DX57FR for…

view full answer...

Answer 8

We actually have the Replacement ECU Service Pack #F69VV which is designed to replace the F3 controller. This way you will not have to replace your harness and only need to replace the ECU.

view full answer...

Answer 9

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 10

The factory prep package on a 2018 Ram 3500 is pretty apparent so odds are you don't have this if you are unsure. If the indentations for the four outer pucks and center gooseneck hitch ball are present but there are no actual holes in the truck…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The etrailer E-Track Roller Idler #e67HR is 3" from the top of the e-track to the bottom of the roller.

view full answer...

Viking Solutions Rack Jack 2 Hoist Reach Dimension

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching