Is Only Way to Order Replacement Landing Gear Leg for Lippert Ground Control with Motor

Question

Question:

Do I have to purchase the entire jack or can I get it without the motor?

asked by: Douglas M

0

Expert Reply:

Lippert does not offer the replacement Ground Control leg part # LC342610 without the motor so the only way to order it is with it.

expert reply by: Jameson C

0

Answer 1

The Replacement Left Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1 #LC305339 is the replacement leg you want. The Lippert #LC342610 is 2 inches shorter and is for travel trailers with this system versus 5th wheel…

view full answer...

Answer 2

The matching right rear leg that is in the short size for the Lippert Ground Control is the part #LC428493 that you referenced. This is same size as the left side part #LC342610 that you have now.

view full answer...

Answer 3

Yes, the left rear leg for the Lippert Ground Control 3.0 Electric 4 Point Leveling System is the same as the left middle leg for the Lippert Ground Control 3.0 Electric 6 Point Leveling System. If your left middle leg measures 17" long then you…

view full answer...

Answer 4

Since your 2019 Open Range 374BHS has the Lippert 6 point Ground Control system and the foot plate is pinned in place the part #LC344792 that you referenced is the correct leg. The part #LC428493 is for if the foot is welded to the jack leg.

view full answer...

Answer 5

The Ground Control jacks for travel trailers are different as they are a C-jack instead of a vertical lift. I recommend using the Replacement C-Jack for Lippert Components Electric Ground Control TT #LC404488 for that application instead of combining…

view full answer...

Answer 6

Assuming that you have the Lippert Ground Control 3.0 stabilization system you can replace your current rear jacks with the Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System #LC428493 as they will be a…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Trailer tire failure can be caused by a number of things. To help extend the life of trailer tires, it is very important to make sure you are not overloading their capacity and that the tires are always inflated to the maximum psi as listed on the…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...