Correct Replacement Brackets for 2010 Chevy Silverado 1500 With Westin Sportsman Grille Guard

Question

Question:

What bracket kit would I need for a 2010 Silverado 1500to mount a 45-2270

asked by: Riley

0

Expert Reply:

The correct replacement bracket/hardware kit for the Westin Sportsman Grille Guard part # 45-2270 which is a fit for a 2010 Chevrolet Silverado 1500 is part # 40-227PK.

expert reply by: Conner L

0

Answer 1

It sounds like you're looking for a replacement installation kit for a Westin Sportsman Grille Guard that fits a 2009 Ford F-150. If so, the Replacement Mounting Kit for Westin Sportsman Grille Guard #40-250PK is the correct kit to install the…

view full answer...

Answer 2

The only way to get the correct replacement mounting brackets for a grille guard on your 2011 Chevy Silverado 1500 is to know the exact model of grille guard you have. The reason for that is grille guards and brackets are year, make, model specific,…

view full answer...

Answer 3

The mounting brackets you need are part #57-229PK. They're specifically for the Westin HDX grille guard, part #57-2295 on your 2010 GMC Sierra 1500.

view full answer...

Answer 4

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 7

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 8

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 9

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 10

So I have your hub narrowed down to a few different possibilities but we need to know what your bolt pattern is to know for sure. We have the part #84556UC3 for if your bolt pattern is 5 on 5 inch. We have the part #845476UC3 for if your bolt pattern…

view full answer...

Answer 11

A drop axle certainly can make it tough to reach the star wheel adjuster on a drum brake. The adjuster spoon tool we offer #W80630 has a 90-degree bend that will often let you get access to the adjuster even on a drop axle. Essentially you will need…

view full answer...

Answer 12

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Correct Replacement Brackets for 2010 Chevy Silverado 1500 With Westin Sportsman Grille Guard

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching