Availability Of Passenger Side Rear Latch Assembly For Extang Express Soft Tonneau Cover

Question

Question:

Part EX 1072 is for a drivers side........i need a passenger side? do you have it?

asked by: Marcus L

0

Expert Reply:

We sure do!

You are correct that the Replacement Rear Latch Assembly for Extang Express Soft Tonneau Cover - Driver's Side # EX1072 is for the driver side, for the matching passenger side assembly you will need the # EX1073.

expert reply by: Samuel C

0

Answer 1

I reached out to my contact at Extang and while there aren't any specific installation instructions available for the Replacement Rear Latch Assembly #EX1072 the process is pretty straightforward. He said you will just need to remove the end cap…

view full answer...

Answer 2

For an xtang Express Velcro, Soft, Roll-Up Truck Bed Cover the correct replacement latch for the driver side would be the part #EX1072. The #EX1073 would be for the passenger side.

view full answer...

Answer 3

For the Extang Express tonneau covers we have the part #EX1072 which is the replacement latch for the driver side. Passenger side is then the part #EX1073.

view full answer...

Answer 4

The driver side latch for the Extang Express is the part #EX1072 that you referenced and the passenger side is part #EX1073. You would want to have latches on both sides of the cover.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

The Husky Center Line Weight Distribution with Sway Control 32217 is for 600 lb to 800 lb total tongue weight capacities (the tongue weight of your fully loaded and ready to go trailer plus the weight of any cargo behind the rear axle of your tow…

view full answer...

Answer 9

Drilling down through the truck bed is required for the installation of any 5th wheel trailer hitch mounting kit with above the bed rails for your 2015 Ram 1500 short bed, including #DM8552030-71. But this is a 4-bolt installation kit so you would…

view full answer...

Answer 10

According to the owner's manual for your 2011 Nissan Armada, if the gross trailer weight (GTW) of your trailer is more than 5,000 lbs then the use of weight distribution is recommended. In addition to the weight distribution system, I also…

view full answer...

Answer 11

The Demco installation kit #DM8552030-71 is compatible with B&W, Curt, Draw-Tite, Hidden Hitch, Husky, Reese, Pro Series and Valley 5th wheel hitches that fit in industry standard above the bed rails. The Demco kit also will not fit if the truck…

view full answer...

Answer 12

We have a few options for a fifth wheel hitch for your 2016 Ram 1500 short bed without air suspension. Since your truck bed is short enough to require a slider hitch to allow you to make tight turns the best option is a hitch that slides…

view full answer...