Installation Hardware for Global Link Vise Lock Door Latch

Question

Question:

Do you sell the self tapping screws for the Global Link Vise Lock for Cam-Action Door Latch?

asked by: Emmett C

0

Expert Reply:

To install the Global Link Vise Lock for Cam-Action Door Latch # 295-000024 you can use the Self-Tapping Screw - 1/4" -14 x 3/4" Long - Zinc # FA1131822.

expert reply by: Erik B

0

Answer 1

The Global Link Vise Lock for Cam-Action Door #295-000024 does NOT include installation hardware so you can select that locally. I suggest stainless or galvanized 6mm diameter hardware that is usually available at any full-service hardware store.…

view full answer...

Answer 2

The Global Link Vise Lock for Cam-Action Door Latch part #295-000024 will be a direct replacement for the vise lock you have on your trailer now. That said, it can only be ordered keyed alike which means if you order multiple and select this option…

view full answer...

Answer 3

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 4

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 5

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 8

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...