Trailer Winch For Adapt-X 500 Trailer

Question

Question:

I would like to use the Adapt-X 500 trailer to haul 2 motorcycles. The ramp is a little too steep to ride the bikes up onto the trailer bed so I would like to mount a winch somewhere in the front of the trailer to pull the bikes up the ramp. Would it be possible to do this and if so do you have suggestions on where and how to mount the winch? What tires come on the Apogee Adapt-X 500 Folding Utility Trailer. Thanks.

asked by: Dave H

0

Expert Reply:

You can use this winch # BDW15020 on your Adapt-X 500 trailer # AT74FR. You can use this mounting plate # BDW20291 to mount it to the front of your trailer. The Trailer Tire is ST175/80 R13.

expert reply by: Adam E

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 4

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 5

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 6

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 7

The weight is 54 lbs for the Superwinch S7500 Trailer Winch #SW1475201.

view full answer...

Answer 8

Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.

view full answer...

Trailer Winch For Adapt-X 500 Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching