Powerful Trailer Roof Vent That Can Be Used With Wall Control Panel

Question

Question:

Want to replace my vent fan in the bathroom of my fifth wheel. It is like the Ventline Ventadome power lift you carry. Want a more powerful fan than that. Something that will hookup to my current wall switch for fan motor and dome lift. Do not want a remote. Also a good seal and double hinge on dome. Thanks for your help.

asked by: Bobby C

0

Expert Reply:

So we can definitely get you a more powerful trailer roof vent than the Ventline Ventadome Roof Vent # V2119-1-533, though the only issue is there isn't one that will be able to utilize your current wall switch, so what you'll need is a vent with a new control panel.

And since roof vents today all come with a remote, what you'll need to do is get a vent and add the control panel to your wall, as there isn't a more powerful option than the Ventline with just a wall switch. What you can use are either of the following:

- MaxxFan Deluxe Roof Vent - Black # MA00-07500K or White # MA00-07000K

This vent does come with a remote control, which is able to mount to a wall (allowing you to use it sort of like a control panel if you want), but since you don't want to use that, you can disregard the remote and add the following:

- Replacement Wall Control Panel # MA59FR
- Replacement Control Cable # MA69FR

This will be the only option for a powerful trailer roof vent with a wall control, as the vent does have a 900 CFM capacity, and includes a rubber weather seal to protect against leaks. For an installation kit if you need one you will need the Roof Vent Installation Kit - Sealant, Butyl Tape, Screws # 344270KITW.

I have added a link below to a video review for you to check out as well.

expert reply by: Kyle S

0

Answer 1

Yes, the Ventline Ventadome Roof Vent part #V2119-603-00 is designed to wire to a switch like the one you mention part #VC0533-03-A. I have attached a wiring diagram for your reference. The Ventadome Roof Vent also comes in white part #V2119-601-00.…

view full answer...

Answer 2

You can utilize a power wall remote switch #VC0533-03-A or #VC0533-02-A (black or white). A rocker switch #BL0108-00 will work and you will need 2 of them. The installation kit #344270KITW will come with screws, tape, and sealant. You will also need…

view full answer...

Answer 3

Ventline produces most of the trailer/RV roof vents supplied as OEM parts so our replacement parts selection should have you covered. If you can find a Ventline part number on your vent base this will help confirm which parts you need in case those…

view full answer...

Answer 4

Since the big difference between the Ventline Ventadome Trailer Roof Vent #V2094SP-30 and the vent #V2119-1-533 is that one has the control right on the unit and the other has a wall mount I see no reason why you can't just unhook the wiring from…

view full answer...

Answer 5

There are only two wires on the Fan-Tastic Vent Roof Vent w/ 12V Fan part #FV801208, a white wire which is the ground and then a black wire which is the power. The ground wire will need to be ran to a bare metal surface and the power wire will need…

view full answer...

Answer 6

I've attached the wiring guide for the Ventline Ventadome Roof Vent w/12V Fan and Wall Switch - Powered Lift - 14-1/4" - White Item #V2119-1-533. There is a white wire that should run from power supply to the fan motor and from the fan motor…

view full answer...

Answer 7

To activate the fan of the #V2119-601-00 you would need to use a switch like the part #VC0533-03-A. For a 5 inch garnish you would need the part #VA0445-37 as well. The part #344270KITW comes with install screws and sealant. I attached a review video…

view full answer...

Answer 8

For your MaxxAir Vent Fan 4951KSC you'd need the replacement circuit board #MA10A21275K. I will say that since your vent has a rain sensor there is a good chance that could be causing your issue. If that part malfunctions it won't allow the…

view full answer...

Answer 9

The motor that raises and lowers the lid of the Ventline Ventadome part #V2119-3-533 that you referenced powers in and out to raise and lower it.

view full answer...

Answer 10

To connect the Wall Control Panel for MaxxAir MaxxFan Plus Roof Vent #MA59FR you will need - if you don't have it - the Replacement Control Cable for MaxxAir MaxxFan Plus Roof Vent Wall Control Panel #MA69FR. You'll need to route that cable…

view full answer...

Answer 11

The model Fan-Tastic fan you have with the wall mount is discontinued so the only option is to replace the fan and remove the wall mounted thermostats. You can replace the vents with the Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote #FV807350 which…

view full answer...

Answer 12

If your current vent has a rough opening size of 14-1/4 square inches then the Ventline vent, #V2119-601-00, is the best option for you. The fan and opening mechanism are powered and can be activated with a wall switch, #VC0533-03-A. To install the…

view full answer...