Parts Needed to Install Redarc Tow Pro Elite in 2020 Subaru Ascent

Question

Question:

I have a 2020 Subaru Ascent with the Subaru OEM hitch installed. I am looking at getting the: Redarc Tow-Pro Elite Trailer Brake Controller - 1 to 3 Axles - Proportional Item # RED44FR I have been reading some of the etrailer QandA and other sites, but have not been able to confirm if I need to purchase any additional items to complete the install for this brake controller. Don’t want to order this and find out i have to order and wait for additional components that I need.

asked by: Adam J

0

Expert Reply:

All you need to install the Redarc Tow Pro Elite # RED44FR is the install harness that was custom designed to match the OEM brake controller of your 2020 Subaru Ascent, part # 3062-P. This plugs into the port under your dash for an easy install.

expert reply by: Jameson C

0

Answer 1

If your 2022 Subaru Ascent has the factory tow package with the factory installed 7-way trailer connector, it will have the factory brake controller connector located above the driver's side kick panel forward of the hood latch as shown in the…

view full answer...

Answer 2

The Tekonsha #118290 is a confirmed fit on the 2020 Subaru Ascent, and it sounds like maybe you're seeing different colors on the wires coming out of your factory harness compared to the one on the on the Tekonsha #118290 harness. I'll start…

view full answer...

Answer 3

There are a few troubleshooting steps to help you figure out why you have no power. I would start by making sure that there is not any corrosion or debris blocking your connection points. If they are clean or still no power after cleaning, I would…

view full answer...

Answer 4

The inline fuse of the Curt T-Connector Vehicle Wiring Harness #C56040 is for the amperage draw of the converter box. When you have the headlights on and press the brake pedal you essentially are asking the box to draw the maximum amount of amperage…

view full answer...

Answer 5

The running light pin on your trailer connector should not be active while the vehicle is off. If that is not the case then most likely the converter box has failed. For replacement, we have the Tekonsha OEM Replacement Vehicle Wiring Harness part…

view full answer...

Answer 6

It sounds like there may be a damaged or missing fuse on your 2020 Subaru Ascent. I recommend checking your fuse panel for any damaged or missing fuses that are identified as trailer or turn signal fuses. You can also test the wiring going into the…

view full answer...

Answer 7

If all of your signals are working there may be no need to connect the wire that is for the 12 Volt trailer power on the Tekonsha OEM Replacement Vehicle Wiring Harness with 7-Way Trailer Connector part #118290 but I can not advise you to do anything…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Parts Needed to Install Redarc Tow Pro Elite in 2020 Subaru Ascent

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching