Determining If A 30 Amp Case Fuse Is Blown
Question:
how do you test the 30 amp square pink fuse that has no external contact point on either side?
asked by: Dan
Expert Reply:
On a square-shaped sealed fuse (case fuse) you typically do not have leads or contact points to test the fuse, as you mentioned. In this case, you usually can see through the top clear section to verify if the fuse is blown (separation of the internal circuit). If you cannot tell using this method, then you use a voltmeter on the lowest resistance (Ohm) setting and connect the two voltmeter leads together and record this reading. Then connect the two voltmeter leads to the contact points on the bottom of the fuse; make sure the fuse is fully removed from any circuit/power. You should have continuity and there should be a very similar resistance reading to what you measured when you touched the voltmeter leads together. If this is not true when you test for resistance then the fuse is blown and needs replaced.
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Swing Out Extension Brackets for HappiJac Truck Camper Jack Systems - Qty 2
- Search Results: reviews
- Search Results: bx88254
- Q&A: Working Running Lights, But No Turn Signals or Brake Lights On Trailer
- Shop: Hopkins Custom Tail Light Wiring Kit for Towed Vehicles
- Shop: Vehicle Tow Bar Wiring
- Q&A: Troubleshooting Brake and Turn Signals Not Working on Tow Vehicle
- Q&A: No Left Stop/Turn Signal Light On Trailer
- Video: Optronics Thinline LED Clearance and Side Marker Light Installation
- Shop: Tow Package Vehicle Wiring Harness with 7-Way Trailer Connector
- Q&A: All Trailer Lights Work Fine Except Brake Lights Will Not Work
- Q&A: Right Side Brake and Turn Signals Not Working on Trailer
- Shop: Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector and Cover Plate - 7' Long
- Shop: Hook Probe Circuit Tester
- Q&A: All Trailer Taillight Functions Work Except Running Lights
- Q&A: Fuse Location for Trailer Brake Controller on a 2005 Chevy Silverado 1500
- Shop: Optronics LED Trailer Clearance or Side Marker Light - Submersible - 3 Diodes - Rectangle - Red Lens
- Shop: Right Angle 2-Wire Pigtail for Optronics Trailer Lights - 2-Prong PL-10 Plug - 6" Lead
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Search Results: trailer hitch wiring
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Video: Choosing the Right Brake Controller
- Search Results: hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: brake controller
- Article: How to Choose the Right Trailer Hitch Class