Will Westin HDX Headache Rack Fit with Tonneau Cover

Question

Question:

Will this Rack work with a tonneau cover on a 2016 F350 or any other racks that will?

asked by: Timothy J

0

Expert Reply:

Since the Westin HDX Headache Rack # 57-8005 installs through the top of the bed rails it would allow a tonneau to fit between it as long as the tonneau cover attaches to the insides of the bed rails like the # TX569101, which fits your truck if it was a short bed.

expert reply by: Jameson C

0

Answer 1

The Westin HDX Headache Rack part #57-8025 that you plan to install on your 2008 GMC Sierra installs by attaching to the top of your bed rails. Since the TruXedo Deuce 2 Soft Tonneau Cover #TX770601 that you are interested in installs on the inside…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

The Class V hitch we have for your 2004 Dodge Ram 2500 with the best ground clearance is the Curt hitch part #C15809. It doesn't tuck right under the rear bumper like what you can see in the attached picture but it does sit the highest.

view full answer...

Answer 8

Thanks for the picture and congrats on the new trailer! There is only one replacement option for the Turning Point Pin Box and it is the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box item #GY48GR. Reese doesn't have one. The Gen-Y…

view full answer...

Answer 9

Thanks for the pictures but no, the EX2700 tonneau cover that the #EX1700 fits is for a 2004-15 Nissan Titan 6' 7" Bed. The one previously mentioned #EX1770 is for your truck, so it'd for sure work if you have the 2770 tonneau cover.

view full answer...

Answer 10

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 11

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 12

For a roof rack/crossbar setup that fits the tonneau cover channels you have on your truck the Rhino Rack Vortex Crossbar Setup part #RRVA180B-RRRLT600 that you referenced is what I would go with if I were you. This gives you a higher quality setup…

view full answer...

Will Westin HDX Headache Rack Fit with Tonneau Cover

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching