Replacement Anti-Sway Cradles For Thule Hitching Post Pro 934

Question

Question:

Hello, I have an older 2012 Thule Hitch Post Pro model 934. I am wondering if you sell separate anti-sway cradles parts for this rack. I see you have them for Thule Archway, Gateway, Roadway, and Vertex Bike Racks. Will these fit the 934 or do you by chance sell them for the 934. Thanks

asked by: David P

0

Expert Reply:

There are still replacement parts available for your Thule Hitching Post Pro Model 934 made in 2012.

It sounds like you are looking for the Replacement Anti-Sway Attachment # 852-2903-001.

You may also be interested in the Replacement Stay-Put Cradle # 853-7887 and Replacement Strap for Cradles on Thule Bike Racks # 852-3006-001.

I included videos for each of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

Definitely! The Thule Hitching Post Pro #TH934XTR uses a lot of the basic Thule equipment including the following: Stay-Put Cradle - #853-7887 Anti-Sway Attachment - #852-2903-001 2" Hitch Adapter - #853-7489 Round Tube End Cap - #853-2181…

view full answer...

Answer 2

The anti-sway cradles part #852-2903-001 for the Thule Trailway which is the same as our Thule Hitching Post Pro part #TH934XTR just snaps onto the main cradle body part #853-7887. It may take a bit of force to do this but nonetheless that is the…

view full answer...

Answer 3

If you need the straps that go along with the Replacement Anti-Sway Attachment for Thule Apex and Helium Aero Bike Racks #1500056128, the straps you need are the #852-3006-001 (1 replacement strap) or #TH534 (4 replacement straps). The straps along…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...