Tread Lite RV Step Module and Motor Replacement

Question

Question:

I am looking for the part number for the replacement motor for treadlight step. I cant seem to find this one anywhere.

asked by: JEREMY R

0

Expert Reply:

The module I can see in your picture is the # LC334850. Which means he correct motor replacement is part # LC183058.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The best way to test this out is by applying 12V power to the motor directly so you can see if it operates correctly outside of the control module (see attached). If everything works properly when you've bypassed the control module then…

view full answer...

Answer 2

If you check out the diagram I attached you will see how the steps should get wired up. What I would first do is verify that you have voltage in all of the right places on your steps to determine if the module needs to be replaced with the #LC301702.…

view full answer...

Answer 3

The Replacement Control Module for Lippert Electric Coach Step #LC301702 is the correct fit for your Lippert Coach step. The long green wire with the ring terminal is your ground and will be attached bare metal to metal on our coach frame. The short…

view full answer...

Answer 4

To begin you will want to begin testing the different circuits of the Step Control Module #LC334850. The brown wire goes to the door switch to tell the steps when to open and close. The yellow wire runs to an ignition switch so that the steps know to…

view full answer...

Answer 5

I attached the wiring diagram you referenced for the Lippert Power Steps Module #LC301702. The second green wire would get grounded to the chassis of the step. The extra wire you mentioned would just need to be capped off and not used like you said.…

view full answer...

Answer 6

The 334850 part number you mentioned refers to the Replacement Control Switch #LC334850. This particular unit replaces the control switch assembly for certain Lippert Tread Lite RV Steps ( #LC353542, #LC353543, #LC353620, or #LC353621).

view full answer...

Answer 7

I went ahead and pulled the Lippert Electric Tread Lite Step for RVs - Double #LC353543 from our warehouse to measure. When completely closed, it measures 26 inches long x 17.5 inches wide x 7.75 inches high. I included a diagram of these…

view full answer...

Answer 8

To bench test the Motor #LC183058 on your Lippert Electric Tread Lite Step #LC353620 you can simply connect the motor wires a 12 volt battery source to operate the motor. The motor is reverse polarity so you can run it in and out by alternating the…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

For your A-frame trailer the Fulton A-Frame Coupler part #FE443050303 would be an excellent choice. This has more than enough capacity at 10k total trailer weight and uses 2-5/16 inch hitch ball which is a more popular size ball for higher capacity…

view full answer...

Answer 12

Hey Jason, I spoke with Furrion and they stated that the Furrion Chill Cube is OEM only currently and should be released to the aftermarket distributors later on this year (2024), but there is no solid date. That says to me that they're probably…

view full answer...

Tread Lite RV Step Module and Motor Replacement

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching