Replacement Tail and Marker Lights for 1996 Ranger Trail Boat Trailer
Question:
Wanting to replace tail lights and sidelights in my 1996 ranger trail boat trailer. I just need the lamps on the side light that would fit into the self grounding brackets that are riveted to the trailer. I would prefer LED’s on tail and side lights if available. The tail light fits snugly in a rubber frame. Tail lights are turn, stop and running lights. I need 4 yellow side lights and 5 red side lights. I can send pics if necessary
asked by: Henry A
Expert Reply:
Excellent idea, switching to LED. They use less power, last much longer and are brighter than incandescent lamps of the same size. Win, win, win.
The grommet mount lamps you reference should fit in a 6-3/4 by 2-1/2 inch rough opening, which is the typical size. I'd recommend measuring the rough opening to confirm. If that dimension checks out, the # TLL12RK LED taillight kit would work well for you.
For the marker lights, if the interior of their mounting brackets measure 2-1/2 by 1-3/16 inches, you'd use # AL91AB for amber or # AL91RB for red. Once again, you'll want to measure to confirm.
Products Referenced in This Question
Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2-1/2L x 1-3/16W Inch
- Amber
- Optronics
more information >
Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Red
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2-1/2L x 1-3/16W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Kit
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diodes - Round - Red Lens
- Shop: Optronics LED Mini Clearance or Side Marker Trailer Light - Submersible - 2 Diodes - Amber Lens
- Search Results: little guy trailers clearance lights
- Shop: Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Amber
- Shop: Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead
- Shop: Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Red
- Shop: Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Shop: EZ Coupler Cap for RV Waste Valve w/ Handle and Gray Water Drain - Black
- Search Results: mcl14ab
- Video: BoatBuckle G2 Retractable Ratcheting Transom Tie-Down Straps Review
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions of Dexter Grease Seal # 010-180-00
- Video: Optronics Trailer Lights - Clearance Lights - MCL52RMB Review
- Search Results: 271594
- Search Results: trailer lights
- Search Results: 281594
- Search Results: wrap around tail light
- Search Results: a91gb
- Video: Optronics Trailer Lights - Clearance Lights - AL90RB Review
- Video: Review of etrailer Trailer Fenders - No Step - HP97FR
- Video: Review of etrailer Trailer Fenders - Slant Back Single Axle Fender - HP48VR
- Video: Review of etrailer Trailer Fenders - Single Axle Fender with Backing - HP29FR
- Q&A: Do Optronics MCL14 and MCL13 Trailer Lights Use the Same Brackets/Trim
- Video: Optronics Trailer Lights - Clearance Lights - AL91RB Review
- Q&A: Side Marker Light that Fits 2018 EZ Loader Skeeter ZX250 Boat Trailer
- Q&A: Replacement Trailer Clearance Light for PM150
- Q&A: Boat Side Clearance Light Replacement for Wedge Shaped Amber Clearance Light
- Q&A: Should Butt Connectors On a Boat Trailer be Replaced with Heat Shrink and Solder
- Q&A: Replacement Taillight Assemblies for 2002 Ranger Trail Boat Trailer
- Shop: Trailer Wiring