Wall Mount for Storing Tandem Bike Rack

Question

Question:

i have a tandem that i would like to hang in my basement. i was looking at the Velo Column mount, the Swagman Fold it Deluxe, and the Velo 2D Wall mtd rack and was wondering if you can make any recommendations OR if any of your customers can? Any advise, guidance would be appreciated.

asked by: Michael C

0

Expert Reply:

Since tandem bikes typically weigh more the Feedback Sports Velo 2D part # 301-16856 would be a front runner as it has the highest weight capacity of 50 lbs. That said, if the weight of your bike is less than 45 lbs I'd go with the Swagman Fold It Deluxe Bike Storage Rack # S80956 since the hooks of the rack can be adjusted out wider which would work better with a tandem bike which is longer.

The part # 301-16835 only has a 40 lb weight capacity.

expert reply by: Jameson C

0

Answer 1

In order to remove the existing hitch ball combo on your Andersen Rapid Hitch Ball Mount like #AM3411, you will first need to remove the internal pin that goes through the ball housing and hitch ball. The small pin has a threaded hole in it, through…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Thanks for reaching out, Tommy! The closest thing we have for your 2024 Honda CR-V is the Curt Trailer Hitch Receiver #C12169 which is a Class II hitch receiver. This means it has the same 1-1/4" receiver opening as the Class I but it just has a…

view full answer...

Answer 4

The Thule fit kit that works with all of their roof racks designed for your 2020 BMW X3 is the Fit Kit for Thule Evo Flush Rail and Edge Flush Rail Roof Rack Feet - 6007 item #TH186007. These custom fit clips and pads attach to the flush rails on…

view full answer...

Answer 5

I have provided a picture that shows the jack dimensions. These measurements were taken here by another Expert recently. The outer tube is 2 inches in diameter and the inner tube is 1-3/4 inches in diameter. The bracket to mount the jack uses a…

view full answer...

Answer 6

We do have 4-Bike bike racks that have the tilting feature that allows you to keep your bikes loaded but unfortunately you have to remove the bikes off of the Swagman XTC4 #S64665 in order to rotate the center mast down to gain rear hatch clearance.…

view full answer...

Answer 7

Personally I prefer the Stealth Hitches Hidden Trailer Hitch Receiver w/ Towing Kit #SH27FRT over the Hidden Hitch by Draw-Tite #DT82GR. Both these are confirmed to fit the 2016-2022 model years of the Volvo XC90. The Stealth Hitches receiver is made…

view full answer...

Answer 8

The Replacement Horizontal Cross Bar for Swagman XTC2 Bike Rack #SP478 is what the wheel holders are attached to on the XTC2 bike racks. That said, this part is only designed to work on the Swagman XTC bike racks #S64671 and #S64670 so we don't…

view full answer...

Answer 9

Take a look at the diagram I provided, which shows the bolt sizes included with the hitch. Four 1/2-13 X 1-3/4 carriage bolts are included, and the other two bolts that are used are preexisting on the vehicle- they're used to hold the bumper…

view full answer...

Answer 10

Yes, the Curt Trailer Hitch Receiver item #C15324 will fit your 2003 GMC Yukon. Depending on your trim package and how low it goes below your bumper you may have to cut an opening in your trim for the receiver to be accessed.

view full answer...

Wall Mount for Storing Tandem Bike Rack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching