Engine Block Heater for 2008 Toyota 4Runner With 4.7L V8 Engine

Question

Question:

Greeting sir or madam: Im looking for an engine block heater for my 2008 Toyota 4Runner 4.7L V8. Do you carry such product? Thank you.

asked by: Tuan T

1

Helpful Expert Reply:

We do carry an engine block heater that is a fit for your 2008 Toyota 4Runner with a 4.7L V8 engine. For that you simply need the following part:

- Kat's Heaters Custom Engine Block Heater # KH11482

This is a frost-plug style heater that is simple to use and to power it you just plug it right into a standard 120-volt AC outlet.

expert reply by: Kyle S

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

There may be a solution for you though the Traffic Cone Holder for E-Track or Rack'em Spare Tire Holder #RA-26 does not have a specific weight rating for one of the brackets. There are a couple options for you to consider like the CargoSmart…

view full answer...

Answer 4

Unless you went with a metal storage box/toolbox like #UWS01020, which is 48 x 20 x 48 and has a 13.3 cubic foot capacity, the Buyer's Products #3371712250 storage box which is 51-1/2 x 19.5 x 22.5 is the largest plastic box we offer. The UWS box…

view full answer...

Answer 5

I checked with Kat's about the correct engine block heater for your 2012 Toyota Tacoma with a 2.7L I4 engine, I confirmed that the correct fit is the Kat's Heaters Custom Engine Block Heater #KH11481. According to Kat's, this will install…

view full answer...

Answer 6

The 4.7L 2006 Toyota Tundra should be a V8 and require the Kat's Heaters Custom Engine Block Heater #KH11482. This would be installed in the 2ndRF position on the engine block.

view full answer...

Answer 7

For the 3.4L engine in your Tacoma, you'd want to use the #KH11482, which installs into the frost plug on the rear left of the engine block, per the diagram I've provided. The KH11813 won't fit your engine.

view full answer...

Engine Block Heater for 2008 Toyota 4Runner With 4.7L V8 Engine

Product Page this Question was Asked From

Continue Researching