Will BAK Revolver Tonneau and Thule SR Ladder Rack Work Together On a 2020 Ford F-350 6-3/4' Bed

Question

Question:

Hello, I am curious if the BAK39330 rolling tonneau is compatible with the Thule track rac sr. Item # TH43003XT-785EX we would like to purchase both. thanks so much!

asked by: Chris L

0

Expert Reply:

Yes, the BAK Revolver X2 Hard Tonneau Cover part # BAK39330 will work with the Thule TracRac SR Sliding Truck Bed Ladder Rack part # TH43003XT-785EX on a 2020 Ford F-350 with 6-3/4' Bed.

expert reply by: Conner L

0

Answer 1

Tonneau covers and ladder racks often interfere with each other when they use the same mounting points on the truck. But since you have the excellent BAK Revolver cover on your 2016 F-150 you can still install a ladder rack from Thule, the TracRac SR…

view full answer...

Answer 2

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 6

Hey Don, the MOLLE Panel for Yakima OverHaul Truck Bed Racks #Y48DJ includes just one panel.

view full answer...

Answer 7

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 8

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 11

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 12

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Will BAK Revolver Tonneau and Thule SR Ladder Rack Work Together On a 2020 Ford F-350 6-3/4' Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching