Roof Rack Recommendation for Leer Camper Shell on 2020 Toyota Tacoma

Question

Question:

Hello I have a 2020 Tacoma 4x4 with a 5ft bed and a Leer camper shell. I am looking to add a roof rack to the camper shell. What products would you recommend?

asked by: Rahn R

0

Expert Reply:

The roof rack we have for the Leer cap on your 2020 Toyota Tacoma is the Thule TracRac CapRac Ladder Rack # TH29200XT.

This is easy to install and has a higher weight capacity that basically matches any roof capacity of the camper shell its installed on.

expert reply by: Jameson C

0

Answer 1

The Replacement FootBase for Thule Tracker #753-2149 is what you currently have on the Thule tracks on your Leer shell. This footbase is for the now discontinued Thule Tracker square bar setup. You may be able to piece this system together even…

view full answer...

Answer 2

The Thule fit kit that fits the tracks you have on the roof of your Leer camper is the part #THKIT3132.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Roof Rack Recommendation for Leer Camper Shell on 2020 Toyota Tacoma

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching