Can Three Keys Be Obtained for a Trailer Hitch Pin Lock

Question

Question:

I want to buy a trailer hitch lock. I noticed that these locks come only with two keys. can you purchase extra keys? Thank you

asked by: Brad E

0

Expert Reply:

That would be dependent on the lock and hitch size, the etrailer Trailer Hitch Receiver Lock part # e98879 for 1-1/4" or part # e98880 for 2" which is what I recommend comes with two keys like most hitch pin locks. If you need extra keys we do offer a way to obtain them using the Replacement Keys for etrailer Hitch and Coupler Locks. That said, you'd need to order the lock first as you will need to know the key number to order more keys.
You can also just ask again when you know the part number and we would be happy to help.

expert reply by: Conner L

0

Answer 1

Excessive rust would definitely weaken the pull of the magnet, so I would recommended replacing the magnets on your trailer if they are severely corroded. If you have power going into the magnet and it is not engaging at all, this again would be an…

view full answer...

Answer 2

Poor or intermittent brake performance can be a result of a few different issues. Poor ground connections, corrosion build up and shorts are the most common culprits. If you are certain that all of your grounds are good, then I would look at the…

view full answer...

Answer 3

There should only be power entering the brake magnets, not leaving them through the ground wire. I would first start off by regrounding each brake magnets to a new bare metal surface separately of one another and as close to the brake assembly as…

view full answer...

Answer 4

You should be able to ground the brake magnets to the frame of the trailer and have them work fine. Or you can try running a jumper wire back from the ground wire of the magnet back to the main ground of the trailer frame. If you are getting 12 volts…

view full answer...

Answer 5

Electric Trailer Brake Kit #AKEBRK-35-SA comes with both the right and left brake assemblies but also new nuts and washers. If you get the brakes individually the nuts and washers are sold separately. If you do not need the nuts and washers then…

view full answer...

Answer 6

As long as your existing hub drums are in good condition (no grooves worn in the armature surface that the brake magnet rides on or the surface that the pads grab). For a lot of trailer hub/drums there is a minimum thickness for that to be turned…

view full answer...

Answer 7

You would know to replace brake shoes the same way you would know with a vehicle. If performance is suffering and adjusting the brakes does not help and there are no other issues causing the poor performance it is probably time to change the brake…

view full answer...

Answer 8

If the surface on the inside of the drum where the shoe pads make contact isn't smooth then a brake shop may be able to turn the drums. If that surface or the surface where the magnet makes contact (called the armature surface) is discolored then…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Yes, the Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31990 will indeed fit on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. The spare tire carrier will work with virtually any 4 lug, 5 lug or 6 lug wheel. The #AM31990 wheel uses the…

view full answer...

Answer 12

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as easily.…

view full answer...

Can Three Keys Be Obtained for a Trailer Hitch Pin Lock

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching