RV Elongated Toilet Recommendation

Question

Question:

I need a standard full time elongated toilet for my rv. I have 10.5 inches from the wall to the center hole. Need recommendations

asked by: John J

0

Expert Reply:

The Dometic Full Timer # DOM87FR is our most popular toilet and will meet your needs. We also offer other Dometic full time elongated toilets in different colors, as well as those that include a hand sprayer, and all of their bowl lengths and bolt holes should work with the location and design of your floor flange. I've included a link to the page on our site that lists all of those models in one convenient location.

expert reply by: Aaron A

0

Answer 1

I recommend using the RV Propane Gas Detector - 12 Volt - 2 Wire - Black #RS44FR and using the larger 7-1/4" long x 3-3/8" wide bracket for the installation as that should be a little larger than your current model 7770.2 gas…

view full answer...

Answer 2

Yes, you can use an offset toilet flange like the one you mentioned with the Dometic toilet you asked about: - Dometic Full-Timer RV Toilet - Standard Height - Elongated Bowl - White Ceramic #DOM87FR I have added a link below to a video review and…

view full answer...

Answer 3

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV…

view full answer...

Answer 4

The Dometic 310 Part-Timer RV Toilet - Standard Height - Round Bowl - Slow Close Lid - White Ceramic #DOM57FR was designed to be able to be used year round, meaning it has some of the same features that a normal "house" toilet will…

view full answer...

Answer 5

Yes, you can use a Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 like you referenced to gain a little ground clearance. This product will allow you to move the axles of your trailer from above the leaf springs to below the leaf springs…

view full answer...

Answer 6

I would begin by troubleshooting the trailer connector on your Durango. Have a helper activate the left turn signal and use a circuit tester like part #PTW2993 on the connector pin that powers the left turn. If you have a 4-pole trailer connector, it…

view full answer...

Answer 7

The seat height of the Dometic #DOM87FR Full-Timer RV toilet is 18-1/4 inches. I've provided a diagram with all the dimensions for reference.

view full answer...

Answer 8

The Dometic Full-Timer RV Toilet part #DOM87FR is a great replacement option for any trailer. That said, toilets aren't make and model specific in regards to fit on a trailer. It may or may not require modifications to be used with a certain…

view full answer...

Answer 9

On the Dometic Toilet part #DOM87FR the distance from the rear of the toilet to the mounting hole center is 11 inches.

view full answer...

Answer 10

Per Dometic the Dometic Full-Timer RV Toilet - Standard Height - Elongated Bowl - White Ceramic #DOM87FR is 8" from the center line of the drain to the front of the bowl so you should be good with your 11" distance from the shower door.

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

RV Elongated Toilet Recommendation

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching