Replacement Propane Gas Detector Recommendation for Older Model 7770.2

Question

Question:

Looking for Propane Gas Leak Detector for 1999 F350 Ford. Model # 7770.2.

asked by: Prakash C

0

Expert Reply:

I recommend using the RV Propane Gas Detector - 12 Volt - 2 Wire - Black # RS44FR and using the larger 7-1/4" long x 3-3/8" wide bracket for the installation as that should be a little larger than your current model 7770.2 gas detector.

expert reply by: Jon G

0

Answer 1

We do have some LP gas detectors available, but none would be a direct replacement for your CCI 7770.2 / Pre Tell 22. From what I could find on your CCI 7770.2 / Pre Tell 22, it has dimensions of 6.25" wide x 3.9" tall. The RV Propane Gas…

view full answer...

Answer 2

You can corner set the Dometic Part-Timer RV Toilet (310 Series) #DOM57FR. You will need 10" as measured from the wall to the center of the hole. Please note the attached image and the installation video.

view full answer...

Answer 3

The Dometic 310 Part-Timer RV Toilet - Standard Height - Round Bowl - Slow Close Lid - White Ceramic #DOM57FR was designed to be able to be used year round, meaning it has some of the same features that a normal "house" toilet will have.…

view full answer...

Answer 4

Yes, you can use an offset toilet flange like the one you mentioned with the Dometic toilet you asked about: - Dometic Full-Timer RV Toilet - Standard Height - Elongated Bowl - White Ceramic #DOM87FR I have added a link below to a video review and…

view full answer...

Answer 5

Yes, you can use a Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 like you referenced to gain a little ground clearance. This product will allow you to move the axles of your trailer from above the leaf springs to below the leaf springs…

view full answer...

Answer 6

I would begin by troubleshooting the trailer connector on your Durango. Have a helper activate the left turn signal and use a circuit tester like part #PTW2993 on the connector pin that powers the left turn. If you have a 4-pole trailer connector, it…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 11

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Propane Gas Detector Recommendation for Older Model 7770.2

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching