Installation Instructions for the Tow Ready 4-Pole Harness for a 2010 Toyota Tacoma
Question:
2010 rear wheel 2.7 4cy tacoma pick up t-connector#118384,how to connect
asked by: Tanvir
0
Expert Reply:
Under the rear bumper, near the driver side of your 2010 Toyota Tacoma there will be a plug with a cap on it that you will remove and plug the 4-Pole Trailer Adapter # 118384 into. I attached installation instructions and video for this product for you to check out that shows you how to install it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Trailer Hitch Drop
- Q&A: 2015 Lincoln Navigator Brake Controller Wiring Harness Connection Location
- Q&A: Replacement Mounting Hardware For A Reese Base Rail Kit
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Can Trailer Hitch Be Installed On 2005 Chevrolet Colorado With Rear Pan Installed
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Options For Pulling a Boat Trailer Behind a 2014 Dodge Ram 3500 with an In-Bed Truck Camper
- Article: Trailer Maintenance Schedule
- Q&A: Recommended Replacement Motorhome Step For A Lippert 163033 RV Step