Can U-bolts of 2013 Toyota Tundra be Reused When Installing SumoSprings

Question

Question:

Will be installing Sumo Spring Helpers1500# on my 2013 Tundra. Some articles say its ok to loosen and reuse u-bolts while other insist they be replaced as u-bolts are Yielding Rolled Thread installed and not to reuse but many do. Whats your opinion and recommendation?

asked by: Red C

1

Helpful Expert Reply:

SumoSprings who is very diligent about making sure their install instructions are safe state you can reuse your u-bolts when installing the part # SSR-610-47 on your 2013 Toyota Tundra.

expert reply by: Jameson C

1

Answer 1

The bounciness you described is most likely due to using a system that is rated too high for your loaded tongue weight. You want to go with a WD system that has a tongue weight range that your trailer falls right in the middle of. If you go too low…

view full answer...

Answer 2

I went out and pulled both the Timbren kit part #TTORTUN4 and #TTORTUN4L from our warehouse to measure them for you and found that they both sit exactly 3-3/4 inches tall.

view full answer...

Answer 3

Yes, you can wire your batteries in parallel and then run them to the Go Power Industrial Pure Sine Wave Inverter - GFCI - 2,000 Watt - 12V #34278156. This will keep the voltage the same but double your amp hours. This is a very common practice with…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

Most hardware will have a range of torque specs they can accept but usually not as wide as 73 to 125 foot pounds. There does seem to be a lot of different information out there so to filter out the bad information the best solution is to contact a…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The difference between the Firestone Dual Air Command Systems #F49VV and F46VV is the the former is only controlled by a smartphone while the latter can be controlled by a smartphone but it also comes with a Bluetooth remote so you don't have to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Can U-bolts of 2013 Toyota Tundra be Reused When Installing SumoSprings

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching