Square Replacement Taillight Lens With 3-9/16" Hole Spacing
Question:
Taillights on my trailer resemble Optronics STL-28RB dimensions 5 x 5 1/4, but square lens 4.5 x 4.5 mounting holes are narrower 3 9/16 inches apart.
asked by: J. O
0
Expert Reply:
The Replacement Tail Light Lens for STL2RB and STL3RB part # AL8RB-1G offers hole center to center measurements of 3-3/4". Which would be very close and as close as I am able to come up with to the 3-9/16" you have. Check it again to see what you get as they are only about 3/16" different.
expert reply by:
Randy B
0
Product Page this Question was Asked From
Miro-Flex LED Trailer Tail Light - 7 Function - Submersible - 20 Diodes - Square - Red - Driver
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5-1/4L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Q&A: Replacement For Furrion FOS48TAPK-BL Back Up Camera
- Q&A: Hitch Pin Weight Capacity and Sheer Strength
- Q&A: Can FloTool RhinoRamps Max Vehicle Ramp Set Hold the Weight of a 2021 Ram 3500
- Q&A: Can I Install the Thinline LED Trailer Tail Light Vertically Where It Will Be Submerged?
- Q&A: Reverse Light PIn on a 7-Way Trailer Connector
- Q&A: Replacement Lens for Bargman 59 Series Clearance Lamp
- Q&A: Color of Light Output for the Optronics Flexible LED Light Strip # UCL90CB
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Maintenance Schedule
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps