Is the HappiJac Remote Cord the Same as a Standard Phone Cord

Question

Question:

Is this plug any different than a standard phone cord?

asked by: Scott S

1

Helpful Expert Reply:

I checked with my contact at Lippert and he tells me that the # LC149557 is different from a standard phone cord since it is designed to work with logic boards that are specific to HappiJac components.

expert reply by: Erik B

1

Answer 1

Having the replacement cable #LC149557 between the #LC723915 and the 723914 and then doing a reset is all that is required to sync the two. To reset the receiver press the ACC-In and ACC-out button at the same time. If this does not work you can also…

view full answer...

Answer 2

I reached out to Happijac for clarification and I was told there are two different remote types. The remotes with the newer style logic boards have 25 amp fuses. Remotes with the old logic boards have 20 amp fuses. If you look at the rear of the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, the Replacement Short Arm Assembly for RV Awnings part #LC404523 is correct for a Solera V000436372 Awning.

view full answer...

Answer 7

To add a in-bed 7-way to your 2024 Chevy Silverado 2500 to make towing with a 5th wheel easier, I recommend adding the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long item #C58FV. This harness puts a 4-way and 7-way…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

To utilize the Titan Chain Sliding Lashing Winch for Flatbed Truck or Trailer #TCLR900 you need the following: - Brophy Winch Bar for 2" Lashing Winch #W2BZ - etrailer Sliding Winch Track #e48ZR

view full answer...

Answer 11

The only troubleshooting you can really do with the K-Source Custom Extendable Towing Mirrors #KS62093-94G would be to check that the wire harness is fully connected and that you didn't blow a fuse in the truck that could've killed the power…

view full answer...

Is the HappiJac Remote Cord the Same as a Standard Phone Cord

Product Page this Question was Asked From

Continue Researching