Will Fan-Tastic Roof Vent with Automatic Lid Work with Vent Cover

Question

Question:

We have an RV with a Fan-tastic Automated Vent, we bought a MaxxAir II Vent Cover - if we use this Vent Cover or even a Fan-tastic Vent Cover will the height of the cover affect the vent opening motor? Since both of these covers are less than the height of the actual vent domes total opening. In your QandA Section, Heather A mentions it wont affect the vent fan motor, but is the opener mechanism a different motor or the same as the fan motor? ?? Dont want for the opener mechanism to burn up.

asked by: Dee G

0

Expert Reply:

This question comes up pretty often but when we've spoken with our roof vent manufacturers they've told us that the lid will stop trying to open if it encounters resistance so the lid will still open far enough to function.

expert reply by: Jameson C

0

Answer 1

The best roof vents we offer for your trailer are going to be the MaxxAir FanMate RV and Trailer Roof Vent Covers part #MA00-955002 for black, part #MA00-955003 for smoke, or part #MA00-955001 for white. The reason for this is because they have the…

view full answer...

Answer 2

Your AC warranty is protected by the by the federal Magnuson–Moss Warranty Act. This act states, in part, that unless the installation and/or the part caused a problem then the warranty cannot be voided. In the real world though, it's certain…

view full answer...

Answer 3

To replace the motor on the LCI Pump 650057 we have the Replacement Motor #LC167576.

view full answer...

Answer 4

If you have the Gooseneck versions of the Curt CrossWing ( #C92DR or #C32DR) you unfortunately would not be able to use the Rota-Flex with it. The pivoting head causing too much strain for the single point of contact you have with a gooseneck hitch.…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Hey Jeff, appreciate all the details you provided that was super helpful and we do have the MORryde cushioned pin box that is designed to replace a Lippert Rhino pin box. For the 17,695 lb GVWR you mentioned on the 2024 Brinkley Model Z 3610, what…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Hey Dan, The ground for the Roadmaster Brake-Lite Relay Kit for Towed Vehicles #RM-88400 typically gets tied into the ground for the braking system to intertwine them so that they're active at the same time. When used to prevent turn signals from…

view full answer...

Answer 10

I am sorry but we do not have an AC cover with those dimensions. The closest option we have is the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners item #AT3308046006 which measures 40-1/2" long x 29" wide x…

view full answer...

Answer 11

The Scissor Stabilizer Jacks w/ Handle item #TJSCHD-24-4 would work great with both your Micro Minnie and the SnapPad SnapJack SJ RV Scissor Jack Pads item #SN32FR you purchased. These have a 10,000 lbs total capacity and expand from 5" to…

view full answer...

Answer 12

The SnapPad Prime Jack Pads #SP84FR4 are specifically designed to fit the Power Gear Leveling Systems w/ 10" Round Concave Jack Feet on your 2014 Fleetwood Bounder 34B. The Pads #SC99MR Stromberg told you to use will not fit on your Bounder as…

view full answer...

Will Fan-Tastic Roof Vent with Automatic Lid Work with Vent Cover

Product Page this Question was Asked From

Continue Researching