What Size Valve Stem Does the Aluminum 15 Liger Trailer Wheel Use

Question

Question:

Do you know the size of the valve stem hole in these wheels? I am trying to check the compatibility with my TPMS system the OEM Ford trailer TPMS/camera kit.

asked by: Andrew

0

Expert Reply:

The Aluminum Liger Trailer Wheel part # LH35FR will have a 0.453" valve stem hole. Generally speaking, wheels under 16" will be 0.453" and wheels over 16" will be 0.625".

expert reply by: Conner L

0

Answer 1

The Aluminum Liger Trailer Wheel - 16" x 6" Rim - 6 on 5-1/2 - Black #LH97FR you have installed on your trailer should not have a PSI rating as this is typically limited by the valve stem, not the wheel. As long as you are using a…

view full answer...

Answer 2

You could use the Americana #AM20906 on your wheels, but your TPMS system is not designed for metal valve stems unfortunately; those sensors can only be used with the brass/rubber stems. If you wanted to switch to metal valve stems you would need…

view full answer...

Answer 3

We actually have had customers make the swap from rubber valve stems to metal valve stems so they can use the TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors #TST-507-FT-4-C. I added the cut out of that review for you…

view full answer...

Answer 4

The seal for your Dexter 4,400 lb axle is part #58846 which we also have in a pack of 2 listed as part #RG06-050 these have an inner diameter of 1.719" and an outer diameter of 2.565".

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 10

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

Hey Jason, for a set of metal valve stems that fit your 2023 Grand Design 2910BH we have the part #AM20906 that you referenced which will fit and work great with your TPMS cap sensors.

view full answer...

What Size Valve Stem Does the Aluminum 15 Liger Trailer Wheel Use

Product Page this Question was Asked From

Continue Researching