How Does Fuse Install in Red Fuse Holder of Curt Trailer Wiring Harness # C56217
Question:
I wasnt clear how to install the 10 amp fuse in the red inline receptacle. Can you provide an image?
asked by: Mark C
0
Expert Reply:
Pull the cap off of the red fuse holder of what comes with the Curt trailer wiring harness part # C56217 and push the metal feet of the fuse into the slots that you can see in the holder.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: How to Tell if 2019 Toyota Highlander Has Factory Tow Package
- Q&A: Recommended Hitch and Wiring Harness for a 2017 Toyota Highlander
- Q&A: Best Trailer Hitch Recommendation For a 2024 Toyota Highlander
- Article: Trailer Wiring Diagrams
- Q&A: How to Determine if a 2017 Toyota Highlander has a Factory Tow Package
- Q&A: Parts Needed to Add 7-Way to 2015 Toyota Highlander For Trailer Brake Controller
- Q&A: Fuse Location for Installation of Curt Wiring Harness on 2018 Toyota Highlander
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Measure for Trailer Hitch Drop
- Article: Most Popular Wheel Bearings