What Crossbars Does Thule Pivoting Tandem Roof Bike Rack part # TH558P Fit

Question

Question:

Will this tandem rack fit on factory installed bars on Toyota RAV4? How about Yakima bars?

asked by: Laurie M

0

Expert Reply:

The Thule Pivoting Tandem Roof Bike Rack part # TH558P that you referenced only can fit Thule square bars and Yakima round bars so while it won't fit the RAV4 factory bars it would fit the Yakima round bars you mentioned.

expert reply by: Jameson C

0

Answer 1

The outer diameter of Yakima round crossbars such as #Y00411 is 1-1/8 inches.

view full answer...

Answer 2

For the Thule Big Mouth bike rack the correct adapter is the Thule #XADAPT2. This will allow your bike rack to install on the crossbars of your rack and work well.

view full answer...

Answer 3

Yes, the 46" Long Inno Square Crossbars #INB117 are compatible with both your Thule Canyon XT Roof Cargo Basket #TH859XT-8591XT and your 2003 Subaru Forester X. Since your Forester has the flush mounted rails you need the Inno Feet #INTR and the…

view full answer...

Answer 4

I went out into our showroom and measured the dimensions of a set of discontinued Thule square load bars and found that they are 7/8 of an inch by 1-1/4 inches. This is identical to the Inno square bars like #INB137.

view full answer...

Answer 5

The only 2 bike add-on that's compatible with the Yakima HoldUp part #Y02479 that you referenced is the EVO add-on part #Y02482. The previous model Holdup is not compatible with the EVO version.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 9

Thanks for reaching out to verify, Frank! Yes, those parts (listed below) will fit great together and on your 2010 Honda Accord Crosstour with the naked roof. Inno Roof Rack - Aero Crossbars #INXB130-138 - Through Feet #INXS250 - Fit Kit #INK587 The…

view full answer...

Answer 10

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 11

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

What Crossbars Does Thule Pivoting Tandem Roof Bike Rack part # TH558P Fit

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching