Towing Mirror Recommendations for 2008 Dodge Ram

Question

Question:

What fits?

asked by: Roy H

0

Expert Reply:

According to K-Source the Snap on Mirror, # KS80700 fits the OE power or heated mirrors, but will not fit extendable or telescoping mirrors. Also available is the Longview Slide on Towing Mirror, part # CTM3100B, which will only work on the black 6x9 inch OE mirrors.

You might also want to check out the Cipa Deluxe Door Mount Mirror, part # 11650. A co-worker has a 2009 Ram 1500, and of all the towing mirrors he has tried, he found the 11650 to be the most vibration-free.

expert reply by: Mike L

0

Answer 1

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 2

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 3

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Answer 4

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 5

I wish I could say yes, but as of right now they are not a fit for the 2016 models and we do not have any other suspension enhancement options. If you are trying to fight suspension sag from the tongue weight of a trailer there is a better option. A…

view full answer...

Answer 6

I'm pretty sure you are correct that the Coil SumoSprings Custom Helper Springs #CSS-1145R will fit your 2018 Toyota Highlander, however, we haven't had the chance to test this out and SuperSprings doesn't have this listed in their…

view full answer...

Answer 7

I recommend installing the Firestone Ride-Rite Air Helper Springs #F2597 on your 2015 Ford F-250 Super Duty. This has a 5,000 lb weight capacity (although it only helps handle the load and won't increase the truck's weight capacity) and is…

view full answer...

Answer 8

The Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2" #C15409 is designed to fit below the factory hitch receiver on your 2008 Ram 3500 dually. The top of the Curt receiver will be 8-1/2 inches from the bottom of the frame where it…

view full answer...

Answer 9

The air bag capacities do not factor in the weight of the truck because presumably the stock components on the truck are still handling that weight. So think of it more like any additional weight you are adding and go from there (keep in mind that it…

view full answer...

Answer 10

To wire the 12 Volt accessory circuit on your 7-Way trailer connector, you should use wire no smaller than 12 gauge, although 10 gauge would be best. We offer the wire you need, the part #is 10-1-1, which is sold by the foot. I would recommend…

view full answer...

Answer 11

The Curt 5th Wheel/Gooseneck Custom Wiring Harness part #C56070 is what I recommend for a 2022 Ram 3500. This will tee in behind the factory trailer connector at the bumper and provide a seven way connection in the truck bed for fifth wheel and…

view full answer...

Answer 12

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...