Bolt Hole Spacing on Westin 40-090PK Replacement Grille Guard Mounting Brackets

Question

Question:

How far apart are the bolt holes where the brush guard mounts on

asked by: Dartagnan

0

Expert Reply:

The bolt holes for the end of the Westin # 40-090PK brackets where the grille guard would mount are spaced 1-1/2 inches center to center and 3 inches on center as shown in the provided photo. This bracket kit is specifically designed for a # 40-0905 Westin Sportsman Grille Guard which fits a 1998-2004 Toyota Tacoma. The bracket kits aren't only vehicle specific, but they're also specific to certain grille guards.

expert reply by: Mike L

0

click to enlarge

Answer 1

The best option we would have would be the part #40-090PK. This is the hardware kit replacement for the Westin Sportsman part #40-0905 that fits your 2002 Toyota Tacoma which it looks like you may have from the picture you submitted. This may not be…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

The Replacement Mounting Hardware #W78XV you found is for the Grille Guard #57-3955 which fits a Silverado 1500. For your 2016 Ford F-150 we have the Replacement Mounting Hardware #W84HR which fits the similar Westin HDX Grille Guard with Punch Plate…

view full answer...

Answer 7

The punch plate refers to the mesh looking section at the top of the grille guard. I attached a picture with it pointed out.

view full answer...

Answer 8

I'm sorry to hear about your loss and I'll do my best to help you out. Grille guards are vehicle-specific, which means they only fit certain years, makes and models of trucks, even if you had the correct mounting hardware. From the photo you…

view full answer...

Answer 9

The correct replacement mounting hardware for a Westin HDX grille guard on your 2017 Chevy Silverado 1500 would be the kit part #57-387PK.

view full answer...

Answer 10

I do have replacement grille guard mounting brackets for you but the grille guard would have to be specifically designed for your 2006 Chevy Silverado 1500 in order for the mounts to line up with both the truck and brackets. Grille guards and bull…

view full answer...

Answer 11

Well the Westing Grille Guard part #57-3555 that you referenced is designed to fit newer Dodge Rams so there is no way that it can be installed on your 2004 Chevy Silverado. Hopefully instead you ordered the part #57-1175 which is the correct HDX…

view full answer...