Westin HDX Grille Guard and Installation Instructions for a 2004 Chevy Silverado 1500

Question

Question:

I just purchased this cattle guard and i need to know how do i install it on my 2004 chevy silverado 1500?

asked by: JOHN

0

Expert Reply:

Well the Westing Grille Guard part # 57-3555 that you referenced is designed to fit newer Dodge Rams so there is no way that it can be installed on your 2004 Chevy Silverado.

Hopefully instead you ordered the part # 57-1175 which is the correct HDX Westin Grille Guard for your vehicle. It comes with a set of installation instructions. But I also attached a picture that has all of the install pages for you to check out as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I can give you the mounting hardware that goes with Westin Sportsman Grille Guards for different models of 2004 Chevy Silverado, though without knowing exactly what guard you have, I would not be able to guarantee a fit in any way. I agree it does…

view full answer...

Answer 2

It sounds like you're looking for a replacement installation kit for a Westin Sportsman Grille Guard that fits a 2009 Ford F-150. If so, the Replacement Mounting Kit for Westin Sportsman Grille Guard #40-250PK is the correct kit to install…

view full answer...

Answer 3

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 4

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

view full answer...

Answer 5

On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…

view full answer...

Answer 6

On a single axle trailer you will want to have a hanger spacing of around 22-3/4 inches when using the 23-1/8 inch long Double-Eye Spring #e59SR. This will allow that rear shackle to correctly lean away from the axle for proper suspension travel.

view full answer...

Answer 7

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 8

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 9

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 10

Trailer makers rarely keep track of smaller items like vent parts used in fabrication of their trailers so finding the right replacement part is often just a matter of measuring, as you have done. Since we do have this item in stock, Ventline…

view full answer...

Answer 11

Sometimes just use of new spring bars can update a weight distribution hitch to match the tongue weight (TW) of a new trailer, but in the case of your Equal-I-zer system, part #EQ37140ET, the highest-rated bars are the 1400-lb set #EQ90-01-1499 that…

view full answer...

Answer 12

I did some checking and basically the cutout bumper is the regular factory bumper. The Curt hitch, #C15312, will fit up tighter and a little more recessed, apparently the same way the factory hitch does if it were installed. Some people like the…

view full answer...

Westin HDX Grille Guard and Installation Instructions for a 2004 Chevy Silverado 1500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching