How To Install the Replacement Electric Jack Switch LC387874

Question

Question:

where is the lead wire to disconnect?

asked by: Justin

0

Expert Reply:

I am not really sure what you are asking but I have attached a wiring diagrams of the Replacement Electric Jack Switch part # LC387874 for you below. I have also attached the function of each wire below as well.

Black Wire - Ground Battery
Red Wire - Power Battery
Yellow Wire (Retract) - Black Motor Wire
Blue Wire (Extend) - Red Motor Wire

expert reply by: Conner L

0

click to enlarge

Answer 1

I attached a diagram that shows where each of the wire colors of the #LC387874 go. Red goes to positive battery post. Black goes to ground. Blue goes to positive when extending. Yellow goes to positive when retracting.

view full answer...

Answer 2

The Lippert High-Speed Power Stabilizer Jack part #LC298707 is a direct fit replacement for the Lippert Ultra Light Stabilizer Jack Model 113407. It does come with a new switch so you can either wire the jacks up to the old switch or install a new…

view full answer...

Answer 3

For your Lippert stabilizer jack set 113407 on your trailer the correct replacement switch is the part #LC144214 for white or #LC387874 for black.

view full answer...

Answer 4

I looked up your GR-9994 regulator and it's a dual changeover vertical regulator so for a cover you'd want the part #CAM59344 and you'd be set.

view full answer...

Answer 5

The Valterra RV Sewer Hose Carrier #A04-5094BK referenced in your question can be safely adjusted to a length of up to 94 inches. The tube has an outer diameter of 5 inches and will simply mount to the frame of your NorthTrail Trailer using the…

view full answer...

Answer 6

The Valterra RV Sewer Hose Carrier part #A04-5094BK could be used without the center support bracket. However, the bracket can actually be placed where you choose so it does not have to be in the direct center. This may then allow you to use the…

view full answer...

Answer 7

What's great about the Valterra RV Sewer Hose Carrier #A04-5094BK is that you can mount it in other places aside from just at the rear under the bumper. I attached a couple pictures that show it installed in a few other places that might give you…

view full answer...

Answer 8

Is there any brand info elsewhere on the stabilizer jack?

view full answer...

Answer 9

No you cannot. The part #LC352338 is a stabilizer jack motor and the part #LC142178 is a landing gear jack motor and is therefore totally different. You have to stick with the #LC352338.

view full answer...

Answer 10

To replace the motor on the Lippert Stabilizer Jacks for your 2012 Cougar Trailer, I recommend the Lippert Jack Motor #LC352338. This is designed to work with Lippert Rear Electric Stabilizer Jacks and is now 2 times faster than the original unit…

view full answer...

Answer 11

The part you are referring to is a circuit breaker, not a relay. In order to test the circuit breaker all you need to do is probe the blue wire that feeds this and then the red wire which is the output. If you get 12 volts on the red output wire…

view full answer...

Answer 12

If the breaker is resetting that means the motor is wanting to draw too much amperage. Since you've replaced the switch already you've narrowed it down to that. For the replacement motor you'd then want the part #LC352338. This is an…

view full answer...

How To Install the Replacement Electric Jack Switch LC387874

Product Page this Question was Asked From

Continue Researching