What Size Wrench Needed to Tighten Softride Replacement Anti-Rattle Hitch Bolt

Question

Question:

Hi, Can you please tell me what size wrench is needed for this nut? Thanks, Alan

asked by: Alan P

0

Expert Reply:

The size of the hex on the Replacement Anti-Rattle Hitch Bolt # SR19696 that you referenced is 22 mm.

expert reply by: Jameson C

0

Answer 1

The Replacement Anti-Rattle Hitch Bolt and Lock Washer for Softride Bike Racks #SR19696 is the correct replacement anti-rattle hitch bolt and lock washer for your SoftRide bike rack, like the Softride Dura Parallelogram 4 Bike Rack #SR26247(no longer…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 8

The Tow Defender #RM-4700 you found is really our best option to protect the front of your 2024 Chevrolet Trax. This screen helps to deflect any road debris back down to the ground to keep it traveling under your Trax. This particular cover is…

view full answer...

Answer 9

I have a solution for you. You can't convert the Thule T2 Pro XTR 2 Bike Platform Rack #TH23JV to a 2 inch hitch according to my contact at Thule so you will need to use an adapter. I recommend using the Brophy Hitch Reducer 2" to…

view full answer...

Answer 10

Hey Thea, sorry to hear about the B and W Tow n Stow part #BWTS20066BMP not fitting super tight in your hitch. This generally isn't a quality issue though as it can be that the tolerances of the hitch it's installed in are too loose. You…

view full answer...

What Size Wrench Needed to Tighten Softride Replacement Anti-Rattle Hitch Bolt

Product Page this Question was Asked From

Continue Researching