Could Custom Third Brake Light Camera kit part # 3460002 Fit 2017 Ford F-250

Question

Question:

I have a 2017 F-250 XLT with the smaller 4.2” I believe in dash backup camera. I was wondering if this product can be wired to the upfitter switches instead of the included toggle switch? Thanks,

asked by: John

0

Expert Reply:

The Custom Third Brake Light Camera kit part # 3460002 is a fit for your 2017 Ford F-250 that has the 4.2 inch screen size on the dash. We do not have a way to wire the switch to the switches you mentioned but I am sure there's a way it could be done.

expert reply by: Jameson C

0

Answer 1

Yes, you will need to adjust the new trailer brakes. You will need to adjust out the shoes until there is a slight but constant drag of the pads on the drum when you turn the wheel. I linked a video to the right and if you fast forward to about the…

view full answer...

Answer 2

To determine the pin weight of your horse trailer you can use a tongue weight scale like the #e99044. I would do that with whatever your current truck is and then you will be able to determine if the new truck can handle the capacity. Because you…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The Third Brake Light Camera part #3460002 that you referenced is not available without a switch, this comes with a gasket which provides the seal but also silicone sealant/butyl tape is recommended, the factory screws of your truck are long enough…

view full answer...

Answer 7

I do have third brake light options for your 2019 Ford F-250 although I am not exactly sure what you mean by interphase. The third brake light cameras available for the 2019 F-250 Super Duty are compatible with what specific monitor have from the…

view full answer...

Answer 8

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

view full answer...

Answer 9

A slider hitch isn't needed with an 8 foot bed truck, but it doesn't hurt anything to use one though. Only downside is that it's going to weigh more than a stationary hitch really.

view full answer...

Answer 10

That's a good question, and we can definitely point you in the right direction for Firestone air bags on your 2021 Ford F-250 Super Duty. The weight ratings are exactly what you said, the amount of weight it can assist up to; so when towing a…

view full answer...

Answer 11

The Truck Bed Cargo Camera for 8" Factory Monitor - Switch Kit part #3460001 does feature a 150 degree angle image and 360 degree adjustable camera. Since your tool box is most likely up against the cab, you can adjust the camera angle to see…

view full answer...

Answer 12

The B&W Companion Slider Gooseneck-to-5th-Wheel Trailer Hitch Adapter #BWRVK3400 weighs 281 lbs. It can be taken apart in sections though to allow it to be easier to manage.

view full answer...

Could Custom Third Brake Light Camera kit part # 3460002 Fit 2017 Ford F-250

Product Page this Question was Asked From

Continue Researching