Will the Curt Friction Sway Control for Weight Distribution Systems Work On a 7K Lb Trailer

Question

Question:

Is the Curt # C17201 Sway Control Ball and Plate sturdy enough for a 25 foot 7000 lb trailer? Im concerned with the small plate and only 4 holes its not strong enough. I have the PRO Series 1000lb WDH system. Thanks.

asked by: BillW

0

Expert Reply:

The Curt Friction Sway Control for Weight Distribution Systems part # 17200 will work just fine on a 7,000 lb trailer although based on the weight it is recommend to use two units, one on each side. The smaller footprint of the mounting plate won't be any sort of hindrance as it is not after all going to be supporting the full weight of the trailer. There also won't be any issues using this unit with a Reese Weight Distribution System.

expert reply by: Conner L

0

Answer 1

The Replacement Ball and Plate Assembly for Curt Friction Sway Control System part #C17201 is the replacement ball and plate for the Curt Friction Sway Control for Weight Distribution Systems part #17200. The plate assembly needs to be 24"…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 5

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 6

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 7

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 8

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 11

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...