Do you have a Replacement Arm for the Falcon 2 Tow Bar

Question

Question:

Good evening Will the Falcon inner arm C00172 work for a Falcon 2 5250 tow bar. The serial number is 06952. Thank you!

asked by: Tim

0

Expert Reply:

Yes the Replacement Inner Arm for Roadmaster Falcon 2 and BlackHawk Tow Bars part # C000172 is a confirmed fit for the Falcon 2 5250 Tow Bar.

expert reply by: Randy B

0

Answer 1

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 2

Yes, we do have full replacement arms for the Roadmaster Falcon Tow Bar 5250, part #910021-70 for the driver or part #910021-80 for the passenger side. We also offer just the inner arm as a replacement, part #C000172.

view full answer...

Answer 3

Yes, the Falcon 5250 tow bar is compatible with the Roadmaster Direct-Connect Base Plate Kit #RM-523196-5 for your 2020 Buick Envision. This particular tow bar has been discontinued for a while now so I would imagine that you'd need the Repair…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 6

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 7

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 8

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Do you have a Replacement Arm for the Falcon 2 Tow Bar

Product Page this Question was Asked From

Continue Researching