Replacement Drum and Cable for Trailer Ramp

Question

Question:

My dad backed a lawnmower over his enclosed trailers door cable and broke the cable loose and broke the pulley attached to the top spring mechanism. Do you guys sell just the pulley from this setup on your site? CB250D96SHD

asked by: Matt P

0

Expert Reply:

The Replacement Drum for M-3 Dual Ramp Springs - Right Hand # DRUM-M-3RH or the Replacement Drum for M-3 Dual Ramp Springs - Left Hand # DRUM-M-3LH is what you are seeking. You also want the Replacement Cables for Conventional Ramp Door Spring - 150" Long - Qty 2 # CAB1-8CB150 from the sounds of it.

expert reply by: Jason S

0

Answer 1

The Enclosed Trailer Ramp Heavy Duty Spring - Dual, 96" Wide #CB250D96SHD is rated for doors up to 250 lbs. I'm confident your ramp won't weigh more than that unless you've added weight to it beyond the decking.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Scott you will need to get the width of your ramp as well as the weight of the ramp to pick out what you'd need. For example the part #M394FR is for 8 foot wide ramps and has a weight capacity of 185 lb. I attached a link to all of the…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

To determine the correct weight springs you will need a scale to determine how much weight is on the door when it lays out on the ground. You will place the scale on the ground in the center of the landing path of the door edge. This will tell you…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

To test the weight of your ramp door, you will want to get the door all the way down to the ground and then on a scale of some kind (a bathroom scale can be used for this if it's the only thing available). This will be when the door is at its…

view full answer...

Answer 8

Hey Lou, so the install of the Conventional Ramp Door Spring part #362SA7218 is something that should be done by someone who has experience winding garage springs. The amount of turns or preload will be the amount that gives you the correct amount of…

view full answer...

Answer 9

Yes, the Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31990 will indeed fit on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. The spare tire carrier will work with virtually any 4 lug, 5 lug or 6 lug wheel. The #AM31990 wheel uses the…

view full answer...

Answer 10

There is not a factory brake controller plug-in port on your 2018 Ford Transit T250 so in order to install your existing Tekonsha Primus Brake Controller you will need to hardwire it in using the Wiring Kit #5506. This kit will provide you with the…

view full answer...

Replacement Drum and Cable for Trailer Ramp

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching