Replacement Antenna For Furrion S Back Up Camera System

Question

Question:

I need to know if you have the antenna only for a furrion vision S back up camera. The manufacturer part number is C-FOSO7TAPK-005. Thank you

asked by: Lesia F

0

Expert Reply:

The replacement antenna for the Furrion S back up camera system is Replacement Antenna for Furrion Vision 1, 2, and S Wireless RV Camera Systems part # 772577.

expert reply by: Heather A

0

Answer 1

We do have the correct replacement antenna for your Furrion FOD43TA-BL camera system, with the correct part being the following: - Replacement Antenna for Furrion Vision 1, 2, and S Wireless RV Camera Systems #772577

view full answer...

Answer 2

The Replacement Shark Fin Camera Mounting Bracket #FRCBRKT-BL mounting holes are 3-11/16" apart from center to center of the holes. The body of the mount where the camera goes is only 3-1/4" wide. With the way the body forms around the…

view full answer...

Answer 3

Typically people run the power wire of camper cameras like the Furrion Shark Fin Mount part #FRCBRKT-BL to the running light circuit of the trailer wiring which allows you to turn the camera on easily inside the vehicle by turning on either the…

view full answer...

Answer 4

We have the VueSMART RV Trailer Backup camera part #HM34FR that will display on a smartphone but the Furrion Vision S system like the part #FOS43TASF does not have a ability to display on smartphone.

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 9

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 10

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 11

Since you have a Dometic AC unit the best option to replace it from Advent would be the part #ACDOM135 which was designed for this exact situation and would allow you an easy install since the electronics would plug right in.

view full answer...

Answer 12

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Replacement Antenna For Furrion S Back Up Camera System

Product Page this Question was Asked From

Continue Researching