Are New Shackle Straps Needed for the Equa-Flex Cushioned Equalizers for Triple Axle Trailer

Question

Question:

Hello, I am looking at this kit for my triple axle trailer. Would I use the stock spring straps or order different ones?

asked by: Brian B

0

Expert Reply:

The Equa-Flex Cushioned Equalizers w/ Never Fail Bushings part # LC281314 will use existing shackle straps, they would only need to be replaced if damaged so you should be just fine. I have attached an install/review video I did on one of these kits for a tandem axle trailer as well.

expert reply by: Conner L

0

Answer 1

The Equa-Flex Cushioned Equalizers w/ Never Fail Bushings #LC281314 that you referenced can attach to the shorter center hangers that you sent in a picture of without any problems.

view full answer...

Answer 2

It does sound like you have found some clear damage to your 5th wheel trailer's leaf springs that will require attention. Uneven tire wear can be caused by a number of things - incorrect pressure, inadequate weight on the axle or a visibly…

view full answer...

Answer 3

There are trailers that leave the factory with different axle spacing, so I wouldn't worry too much about the difference. To determine the correct replacement equalizer I recommend measuring the distance between the horizontal mounting holes in…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 6

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 7

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 8

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 9

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

The absolute best cushioned equalizer that fits the dimensions you mentioned having would be the MORryde ALLTREK 4000 part #MR89DR as this is only option to provide vertical and horizontal cushioning. This would make a big difference and you'd be…

view full answer...

Answer 12

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…

view full answer...

Are New Shackle Straps Needed for the Equa-Flex Cushioned Equalizers for Triple Axle Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching