Cushioned Equalizer Replacement for EQ356  

In regards to replacing or upgrading an equalizer like part #LC696740, you'll need to use one with the same or similar dimensions as the existing. The most important dimension is the distance between the lower two lowermost holes. If there…

The Road Armor equalizers, part #LC696740, are 3-1/4 inches tall from the center of the top bolt hole to the line where the center of the lower bolt holes straight down. They're shorter than your 13-10 equalizers but they're the closest…

The distance between the horizontal mounting holes on the Lippert Road Armor Equalizers part #LC696740 is 6 inches and the distance between the mounting holes of the #TREQ104 you mentioned is 5-3/4 inches. This would be close enough to fit and work…

The rubber on both the yellow and blue Road Armor Shock Absorbing Equalizer Kit - Tandem Axle - Qty 2 #LC696740 is not designed to be rebuilt or replaced. The amount of time they last depends on many different factors so there is no estimate that can…

When installing the Road Armor Shock Absorbing Equalizers #LC696740 you'll want to use a torque wrench on the bolts and torque them to between 30-lbs/ft and 50-lbs/ft torque. I confirmed this with my tech contact over at Lippert.

The Road Armor Shock Absorbing Equalizer Kit - Tandem Axle - Qty 2 #LC696740 measure 6 inches center on center. They can work for your 7 inch equalizer replacement, but you may need to replace shackle straps to make up any differences depending on…

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

The AllTrek 4000 kits provide the best cushioning so if you were to upgrade from your CRE3000 kit to the Alltrek you would see a big improvement. If you have a 35 inch wheelbase you'd want the part #MR29DR or if you have a 33 inch wheelbase…