Trailer Lights for 12 Volt and 24 Volt Systems on a 1994 Mercedes G Wagon and Honda CR-V
Question:
I would like to use my utility trailer with my two tow vehicles one with 24V electrics above and the other Honda CR-V 12V. My question is if upgraded trailer tail lamps to Optronics LED would this allow me to do this without problem?
asked by: Alex
Expert Reply:
Some trailer lights can be used on either a 12 volt or 24 volt system, but # STL16RB is not one of them. You could use # STL23R24B with harness # A47PB, grommet # A45GB, bracket # BK45BB for a 24/12 volt system and it would work with both vehicles.
Products Referenced in This Question
Rubber Grommet for 4" Round Trailer Lights - PVC
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 4 Inch Diameter
- Grommet
- Round
- Optronics
more information >
Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Three Wire
- Right Angle Pigtail
- Optronics
more information >
Trailer Light Mounting Bracket for 4" Trailer Lights, Steel - Black Powder Coat
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 4 Inch Diameter
- Brackets
- Black
- Optronics
more information >
Miro-Flex LED Trailer Tail Light - Stop/Turn/Tail - Submersible - 12 Diodes - Round - Red Lens - 24V
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Product Page this Question was Asked From
LED Combination Tail Light for Trailers over 80" Wide - Submersible - Red - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Clearance
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 8-1/16L x 2-7/8W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Size Comparison Between the Bulldog Replacement Jack Screw and Nut BD500250 & BD500217
- Article: Trailer Wiring Diagrams
- Q&A: Replacement for Wesbar 102641 Tail Lights
- Q&A: Timken Replacement Bearing Solution for Setup with Part Numbers L44649 471750 L44610
- Q&A: How to Read the Lippert Components Axle Description Measurements
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Q&A: Dimensions Of The Over The Seal Strap Hinge # PLR2116-SS
- Q&A: Length of Replacement Handle with Claw Knob for Square Jacks
- Article: Rooftop Cargo Carriers
- Article: Trailer Maintenance Schedule
- Article: Best Boat Trailer Jacks
- Article: Trailer Lighting Requirements
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)