Are There Quick Fist Clamps For Smaller Diameter Objects

Question

Question:

I purchased some quick fix clamps and they are to large do you have smaller clamps

asked by: Dennis S

1

Helpful Expert Reply:

The Quick Fist Clamps are offered in a few different sizes and configurations. The Quick Fist Mini Clamps part # QF30050 for example fits 5/8" - 1-3/8" diameter objects. I have attached a full list of options below.

expert reply by: Conner L

1

Answer 1

I was unable to obtain a detailed drawing of the Quick Fist Original Clamps #QF10010 and Mini Clamps #QF30050 referenced in your question, but I am able to provide you with some measurements and instructions that may help with your application.…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Both the Saris Freedom 4, part #SA4414B and the Yakima HoldUp, part #Y02443-2 are great racks and they do have a few differences. In looking at the racks, the distance can vary by quite a bit based on what vehicle the racks are installed from. When…

view full answer...

Answer 5

Yes, the Batwing Awning #RR33100 (Driver's Side) or #RR33200 (Passenger's Side) can be mounted to your Yakima JetStream crossbars so long as they extend out past your roof rack's feet. They have mounting brackets which install inside the…

view full answer...

Answer 6

Yes, we do have foam pads that will fit around your Rhino-Rack Heavy-Duty Roof Rack Crossbars #RB1250 and allow you to carry your surf board. You can use the Rhino-Rack Crossbar Pads w/ Tie-Downs #RRRWP04. These pads will fit your HD crossbars. I…

view full answer...

Answer 7

The dimension you are looking for on the #RR31102 is 1-1/2".

view full answer...

Answer 8

The Rhino-Rack Heavy-Duty 50-Inch Roof Rack Crossbar #RB1250S has cross-section dimensions of 1-7/8-inches tall and 1-5/8-inches wide, as shown in the photo I prepared for you. We also offer two bars as a set #RB1250. The vehicle known as the…

view full answer...

Answer 9

I measured the widths of the c-channel on the Rhino Rack Vortex Aero Crossbars and the bottom width is 7/8 inches and the neck width is 7/16 inches. I have attached a photo showing these measurements for you to check out. As long as the t-bolts on…

view full answer...

Answer 10

Rhino Rack offers the RT-Style Roof Rack Track that would mount directly to the roof of your 2008 Ford Ranger with pop rivets. You will need a rivet gun to install this track so if you do not have one already, you could purchase one from a local…

view full answer...

Answer 11

The Rhino-Rack CXB Leg Kit for Raised, Factory Roof Rack Side Rails #CXB will fit the factory rails on your 2022 Subaru Forester as long as those rails are not more than 1-1/2" tall and not more than 2-1/4" wide. This would allow you to use…

view full answer...