LED Light Replacement can be Used in Optronics Trailer Interior Dome Light IL21CB

Question

Question:

1L21cb dome interior light can it use led 2 prawn I have. Rv and I have a 2000 class a motor home with a few broken 12 v led holders I use led bulbs does the 1L21CB. Use led bulbs. That you sell .

asked by: Michael D

0

Expert Reply:

The light you mentioned # IL21CB uses a 1156 bult which we offer LED versions of with the # DI67ZR for a cool white or part # DI77ZR which puts out a warmer white color.

expert reply by: Jameson C

0

Answer 1

The Optronics LED RV Interior Double Dome Light with Switch #RVILL34 has not been known to cause any interference whatsoever with TV, and I can imagine that what you are experiencing is extremely frustrating, though this light will not cause any of…

view full answer...

Answer 2

You can wire in the Optronics light #IL21CB to either the 12 volt circuit or the running light circuit. To wire it to the running light circuit, just tap into running light wire on the trailer. To turn the light on you would need to have the trailer…

view full answer...

Answer 3

We have yet to have any issues with our LED trailer lights interfering with radio frequencies. The #RVILL34 will would not be an issue at all in that regard. None of our customers who have bought this have reported interference issues.

view full answer...

Answer 4

To determine the size of the receiver lock you will need you need to determine the size (see link below) of the receiver on your vehicle and you also need to measure the overall width of the outside of the receiver at the hitch pin hole. If you have…

view full answer...

Answer 5

To find the correct replacement lights for any trailer you will need to find the manufacturer and model number which would be on the light housing, not the lens. If that information is not available, you will have to go by the measurements of the old…

view full answer...

Answer 6

In the case of the 921 bulb style, you will not necessarily get a brighter light with an LED model like the Putco 921 LED Bulbs, #P340921W-360, that you mentioned. In my opinion the light from this light is whiter than the light from and incandescent…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

LED Light Replacement can be Used in Optronics Trailer Interior Dome Light IL21CB

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching