Landing Gear Replacement Leg for 2007 Alpenlite Defender

Question

Question:

Please see the attached picture and description of what we need

asked by: Rick T

0

Expert Reply:

I thought I had a replacement leg setup that would work for you till I read that you have a motor on each of the landing gear legs. Is there anyway you could send me a picture of what you have so that I can see if I recognize it?

expert reply by: Jameson C

0

click to enlarge

Rick T.

4/7/2020

Please see the attached picture and description of what we need

Reply

Jameson C.

4/7/2020

Thanks for the pictures! Based on that the correct legs your 2007 Alpenlite Defender needs is the part # LC179013 for the lead leg and part # LC179014 for the follow leg.

Reply

Answer 1

It doesn't sound like the gears to me because you are able to retract all but the 2 inches, so I don't think the Lippert Components Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear #LC146059 will solve your problem. If the gears were…

view full answer...

Answer 2

The distance from the top of the upper weld of the Lippert leg part #LC179013 to the center of the shaft measures 6.4 inches.

view full answer...

Answer 3

Trailer makers like Jayco typically don't maintain details on the specific landing gear brands they install but we do offer replacement parts and service kits for most brands out there. But since your jack tube is bent you'll need to replace…

view full answer...

Answer 4

Your 2000 Jayco Eagle likely uses either Stromberg Carlson Electric Landing Gear Set #LG-1 or a Lippert setup like Lippert Electric Landing Gear Set #LC333964. You will want to confirm this, but if you need the replacement lead leg for Stromberg…

view full answer...

Answer 5

Thanks for all of the details, Tony! The best replacement for your application is the 25-1/4" Long 5-Leaf Double-Eye Spring for 6,000-lb Trailer Axles #e34SR. Trailer leaf springs can grow a little longer over time and will also be a little…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...