Is Drive Nut Replaceable on 2,000 lb A-Frame Trailer Tongue Jack
Question:
Doesnt someone sell the 1 7/8 round drive nut ,3/4 inch diam. threaded center- to replace the stripped out one on top of inner pipe on these jacks. They are stamped into top of inner pipe, but easy to remove. I need a new one. Here is pic of drive nut -round 1 +3/4 to 1 7/8 diam.,and 3/4 inch diam flat thread screw drive center. No part number or name on it.I believe it is Fulton or same as your new ones? Thanks
asked by: Jim W
Helpful Expert Reply:
I did some digging but unfortunately it doesn't look like that nut is replaceable all on its own. I think that is typically changed out with the screw but even then I wasn't able to find anything for a 2K Fulton jack. When I reached out to my contact at Fulton he said that it's actually cheaper to replace the entire jack than it is to replace that screw nut anyways so he recommended just replacing it instead.
For a replacement jack I recommend the Bulldog Round, A-Frame Jack # BD155033 because of how easy it is to use and how reliable Bulldog jacks are. This jack has a 2K weight rating and a 2-1/4" out/2" inner tube design. While the tubes are a little bigger than what you currently have, the mounting hole pattern should still match up just fine which is 3" apart on center. I recommend using the footplate # BD018564 with this jack.
Attached is a review video for you to check out.
Products Referenced in This Question
Replacement Square Footplate for Bulldog Round Trailer Jacks w/2" Diameter Tubes - 2" Tall
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- 2 Inch Diameter Tubing
- Bulldog
more information >
Product Page this Question was Asked From
Bulldog Round, A-Frame Jack - Topwind - 15" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Ultra-Fab Ultra Scissor Jacks - 24" Lift - 13,000 lbs - Qty 2
- Shop: Stromberg Carlson Base Pad Extreme for RVs and Trailers - 6,000 lbs - Qty 4
- Video: Timbren Vehicle Suspension - Rear Axle Suspension Enhancement - TGMRG25C Review
- Video: Timbren Rear Suspension Enhancement System Installation - 2003 GMC Yukon XL
- Search Results: timbren
- Search Results: trailer dolly
- Shop: Suspension Enhancement
- Shop: Strait-Line Weight Distribution System w/ Sway Control - Trunnion Bar - 8,000 lbs GTW, 800 lbs TW
- Shop: Timbren Active Off-Road Bumpstops - Rear Suspension - 3,600 lbs
- Shop: Timbren Rear Suspension Enhancement System
- Shop: Timbren Active Off-Road Bumpstops - Rear Suspension - 3,000 lbs
- Video: Reese Strait-Line Weight Distribution System Review
- Search Results: load leveling hitch
- Search Results: trailer valet
- Search Results: bal leveler
- Search Results: ramp
- Video: Review of Furrion RV Camera System - Wireless Camera with Monitor - FOS05TASF
- Video: Trailer Valet JXS Trailer Jack with Footplate Review
- Video: Ultra-Fab Ultra Scissor Jacks Review UF48-979002
- Video: Hopkins VueSMART RV and Trailer Backup Camera Review
- Shop: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Trailer Maintenance Schedule
- Q&A: Replacement Motor For Power Gear Part 1510000006 On 2006 Fleetwood Fista
- Article: Trailer Wiring Diagrams
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Article: Top Gifts for Dads in 2024
on Trailer Jack
