Does Timbren Suspension Enhancement System for 2013 Honda Pilot Work on 2WD and 4WD Models

Question

Question:

What is the difference in the two Timbren HROD2 suspension enhancements that you offer for the 2013 Honda Pilot? One says for 2WD vehicles and the other says for 4WD vehicles. However, I do not see anything in the specs or on Timbrens website that states there are in fact a 2WD version and a 4WD version. Everything I see seems to stated the HROD2 is the same for both the 2WD Pilot and the 4WD Pilot. Whats the difference?

asked by: Travis B

0

Expert Reply:

You are correct - the Timbren Rear Suspension Enhancement System # THROD2 is the same part for the 2-wheel drive version and 4-wheel drive version of a 2013 Honda Pilot, so there isn't a difference.

Since the part number is exactly the same, it is is just listed for a 2WD and 4WD separately so people know that no matter which model they have of 2013 Honda Pilot, this model will work for them.

I have added a link to a video review as well as a link to an install for you to check out of the Timbren Rear Suspension Enhancement System # THROD2.

expert reply by: Kyle S

0

Answer 1

I called my contact at Timbren about the Rear Suspension Enhancement System, part #THROD2, and I also called my contact at Firestone about part #F4179. If you have a strut that is running down through the middle of your rear coil springs then neither…

view full answer...

Answer 2

There are a few different suspension enhancement systems you could use for your 2006 Honda Pilot. I have included a link to them for you. The Firestone Coil-Rite springs, #F4179, will replace the factory overload bumpers that are in the factory…

view full answer...

Answer 3

The disc goes above the spring and the air line comes out of the bottom of the bag. If you check out the picture I attached you'll see a diagram of how it all goes together.

view full answer...

Answer 4

The Prodigy P2 #90885 is an excellent choice, being one of our most popular and easy to use brake controllers of all time. To install the brake controller, first look under the dash under the steering column over the brake pedal as shown in the…

view full answer...

Answer 5

The 2,000 pound weight capacity rating for Timbren helper springs #THROD2 is the amount of downward force the springs can handle. So that would be the tongue weight of the trailer plus anything loaded in the 2014 Acura MDX.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

We can definitely get you set up. For a 7-way wiring harness for your 2024 Honda Pilot trailsport I recommend the Curt T-Connector #C35ZV which will plug in to the existing tow package connector at the rear your vehicle. I do also recommend getting…

view full answer...

Does Timbren Suspension Enhancement System for 2013 Honda Pilot Work on 2WD and 4WD Models

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching