Replacing Sylvania Microwave SR-11092B in RV

Question

Question:

My 2009 big country had a SR-11092B/SR In it, what are my replacement options?

asked by: Malia T

0

Expert Reply:

The dimensions of your Sylvania Microwave SR-11092B are 12-1/4" tall x 20" wide x 13" deep which the Greystone Microwave part # 324-000105 would be an excellent fit as a replacement since it measures 12" tall x 19" wide x 14-5/8" deep.

The Furrion microwave part # FMSN09BL has similar dimensions too at 19-1/16" long x 13-5/8" wide x 15-7/8" deep.

expert reply by: Jameson C

0

Answer 1

I looked up the dimensions of your Sylvania Microwave SR-11092B (12-1/4" tall x 20" wide x 13" deep) and compared them to that of the Greystone Microwave part #324-000105 (12" tall x 19" wide x…

view full answer...

Answer 2

The best replacement we have for the Sylvania Microwave SR-11092B is going to be the Greystone Microwave part #324-000105. This microwave comes with its own frame that will need to be used but it should cover your cut out so you will never be able…

view full answer...

Answer 3

I reached out to my technical contact at ASA Electronics (Advent Air) and she let me know that the only solution if you're not able to find the replacement Carrier control board is to then replace your existing air distribution box and…

view full answer...

Answer 4

If your RV step's motor is dead (no operation even if you bypass the switches and directly apply 12V power to the motor terminals) then it will require replacement. Your gearbox may still be okay so long as it has not made bad noises when it…

view full answer...

Answer 5

I looked up your discontinued Dometic DOTR12CBIV and was able to find that it measures 16-1/8" tall x 22" wide x 16-5/8" deep so the closest replacement option we have is the Greystone Standard RV Microwave w/ Trim Kit #324-000106.…

view full answer...

Answer 6

We have exactly what you are looking for. You will want the Atwood combination gas and carbon monoxide detector #AT36681.

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 10

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Replacing Sylvania Microwave SR-11092B in RV

Product Page this Question was Asked From

Continue Researching